Recent content by 295W

Thanks everyone! The diagrams are great!! Do I have to use a solenoid I'm just getting this engine to fire and then maybe run a bit.....?

know I am posting to an old post but.... I have started my engine well turned it over using a 68 chevy coil but the parts store only had a generic resistor. The engine will not kick over with the wiring through the resistor but will with out it. I measure 2.9 volts or there about with the...

$100 each for the front and rear ends & $100 for the wheels - believe these are 16's the tires on them are & 5 on 5.5 If my prices are too high - make a reasonable offer

Thanks the 12 point box 7/16" was what to use. The trick or tip I was looking for I found myself - open the windshield and there is access from above through one of the vents :-) one unscrewed one broke not bad for 84 year old hardware....

I have a 29 5 window coupe that I am doing a frame off with and putting an 8BA in. Well I am almost done stripping her down and have removed all the bolts on the tank except to inside the cabin at the very edge on either side. I just can not put a wrench or other tools I have tried on the nuts -...

Re: 29 motor and trans Motmo Sent you a PM

This was running in the car - click on picture to hear it run do not want to ship

I know this is an old thread, but I have a used axle and a new kingpin set and the kingpin seems very tight going into the axle - like it would need to be driven into the axle. I had someone tell me to clean it up with sand paper and a dowel - there does seem to be some dirt, paint etc. in the...

Interested in the Rumble seat platform and I am sort of local - Benicia, CA - send me a couple of pics