Recent content by 1934Victoria

I wonder if anyone have a picture of the tilt stop bracket that sits underneath the passenger front seat on the 1934 tudor. From what I found this was added later in the 1934 production run. On one of my floors there is a welded on bracket on the floor under the front seat, and I would like...

Looking for 1934 Ford Tudor standard garnish moldings for the drivers door and passenger quarter window. Also interrested in just the lower piece of the door garnish. /Daniel

I need help to identify what model year these parts come from. The window channel holder came with some 1933 tudor parts, but not sure if it is the rear side window channel or not for that car. Let me know if measurements is needed for identification of the spark wire tubes. Thanks

Okay! Thanks for the info.

I wonder if there are any differences between the rear side window garnish mouldings for a 1933 to 1934 tudor? I know about the difference between a standard and deluxe 1934 garnish, but are there any other differences when comparing a standard 1934 garnish for the rear side window with a 1933...

I have a Vicky that came from south America, right hand driven once. However this extra cowl came from USA. I will check to see if it has any holes for the body tag.

I checked and the tag is gone on my cowl. Does anybody know if all closed car cowls were made at the same factory, or did they come from different body manufacturer. Are there any information which body manufacturer that manufactured a certain body type in 1934. Who manufactured the different...

I will check my cowl to see if it has any numbers stamped to it. Thanks for the info!

I have a cowl for a 1934 car (body with fixed roof) and I wounder if there is any way to tell what type of body it came from? Are there any spotwelds or anything that might differ and tell what body it was originally installed at?

Thanks all for the info on this one! I suspected that they didn't need to be used since all the regulators had the stop screws in my car. However it kept me busy for a while searching for a place that they might fit in.

Hi Does anyone know where these rubber pieces shall be attached. Came with both the door and rear window channel kit for the 1934 tudor/Vitoria. Seen that they shall work as a window bumper, but dont find any place to put them. Regards, Daniel

Thanks for the info! I will give them a call.

Hi I'm starting a restoration of my 1934 speedometer and wonder if anyone know what surface threatment Ford used on the dial face of the gauge. I have noticed that the 1933 have somewhat more yellow gauge dials than the 1934. Regards, Daniel

Do you still have the seat, if so I´m interrested. Contact me. Regards, Daniel joyride76@hotmail.com

Do you still have the seat? If so I´m interrested. Contact me. Regards, Daniel joyride76@hotmail.com