35 p/u dash ?

Steel 35

Steel 35

Senior Member
I put the screws in order in an egg crate; Now I just don't know the order! this is the second set of screws I have put in the forward side holding the dash in, and now wonder if they go inside along the bottom, inside seams to have a larger hole? Won't stop the world from turning but would like to get it correct. Thanks as always



picture.php
 
They are the same size screws. (Don't recall the exact size at the moment.) Holes may have been wallowed out over the years. Mine were in my 35. You have the ones shown in correctly. The ones that go on the bottom edge of the belt rail have a leather/rubber washer under them.
 
Lawson Cox said:
They are the same size screws. (Don't recall the exact size at the moment.) Holes may have been wallowed out over the years. Mine were in my 35. You have the ones shown in correctly. The ones that go on the bottom edge of the belt rail have a leather/rubber washer under them.
Click to expand...

Sorry but I am still confused I have the fiber/leather/rubber washers installed here in the front guess i forgot to mention that, and I don't have enough for both, so the washers go to the inside?
 
Thanks Lawson, Rather then pull the six screws, I left them and got 6 more washers at the plumbing supply store and added them to the (belt rail)? I am good to go and can see how the holes could be wallowed out; That took a good part of the day to line the little crank handle up.
 
Yes, I had trouble aligning the hole and the crank handle myself. Finally got it right and the regulator works a lot easier. lol
 
You must log in or register to reply here.
Back
Top