Stupid question re rear spring

BobbyG

BobbyG

Senior Member
Guys - On my coupe - the area inside the trunk on the floor directly above the rear crossmember that the rear spring sits in - I have a metal panel that is fixed flush with the trunk floor.

Now - Todays job is re fitting the rear end & spring BUT I also want to fit new U bolts

Am I right in thinking that the panel directly above them that appears to be 'stuck' in place with seam sealer HAS to be removed in order to get the old U bolts out and new ones in ?

Bob
 
BobbyG said:
Looks like thread is damaged - nut flew off at me
Click to expand...

The center bolt may be rusted in two, and that would leave a lot of pressure on the 2 u-bolts. I assume you were in the process of removing the rear end?:confused:

If possible I would reuse the u-bolts and nuts. The last few threads on the u-bolts could be cleaned up with a threading file.
 
Proceed with caution if the nut flew off at you. Like Tom said it is likely the center bolt is broken. Take a couple of large C-clamps and try to clamp as much of the rear springs back together. Then see if you can take a punch and drive out what is left of the bolt. If you get it all out try to put a piece of allthread through the springs and a nut on ontop to help hold it all together. Rear springs are dangerous to work on. Rod
 
You must log in or register to reply here.
Back
Top