Parts Diagram?

This??
 

Attachments

  • rear_axle_schematic.jpg
    rear_axle_schematic.jpg
    47.8 KB · Views: 163
No Gaskets between 1 & 3 or 3 & 4? Just steel on steel? That seems like a good place to leak when a couple paper gaskets could prevent it.
 
The only things missing from the diagram in post #2 are the front seal, roller bearing, bearing race, thrust washer, speedometer gear, and retainer ring.
 
Where did you get that diagram Brent? Do any of the parts suppliers have diagrams on their sites? Diagrams make life a lot easier.
 
Look up the Long Beach Model A club. They have a list of different PDF's you can download, one of which is for rebuilding the rear end. That has been my go to for the ones I have rebuilt.
Heads up, gasket 10, those are shim gaskets and come in a set of different thickness for setting the carrier bearing preload, it isn't just one gasket. The gasket set shown on the Snyders page is made by Best, which in my OP is the "best" set. :)
https://www.snydersantiqueauto.com/product.htm?pid=978065&cat=41627
 
According to terry Burtz, there is no gasket between the pumpkin and torque tube on a model A.
 

Attachments

  • IMG_0383.jpg
    IMG_0383.jpg
    18.6 KB · Views: 23
You must log in or register to reply here.
Back
Top