Need assistance in buying an inline pump. Made a mistake buying Edelbrock Micro, which their Tech guy said is not right, as it is gravity feed only. He recommended p/n 1791. Application is 37 Ford. I have regulator @ about 3 lbs., running 2 Stromberg 94s on B&M blower. Engine 284 cid. Want to mount it on frame rail above rear axle. Any suggestions? Thanks.
Electric Fuel Pump
- Thread starter 91A-77B
- Start date
pbsdaddy
Member
I used this one on my 49 F-1 with an 8BA. It worked great. Mounted right to frame between tank and engine. https://www.amazon.com/Universal-El...arburetor/dp/B08LVLBNBF/?tag=atomicindus08-20
Lawson Cox
Well-known member
There ain't nuttin' wrong with Henry's stock mechanical pump. I have driven all over the country and parts of Canada with one. I will confess that I have a mechanical pump that I use only for PRIMING when my pee cup sits for a long time.
alchemy
Well-known member
You’re a little mixed up. Stromberg didn’t make 94’s. Do you have 97’s, or Holleys? Then, no matter which kind you have, set your regulator to 2 pounds.
Flathead Fever
Well-known member
It's best to get an electric fuel pump with the pressure reading you need rather than getting one with too much pressure and then putting a regulator in line to cut the pressure down. It needs to be mounted close to the fuel tank and have a good-sized fuel filter mounted "before" the pump to protect it. Then if you are going to run an electric pump just to prime the engine and run off of the mechanical pump once its started. You need to make sure the electric pump is in the "open position" when there is no power to it so the mechanical pump can pull fuel through it. Most electric fuel pumps are in the closed position when there is no power to them. The Airtex Fuel Pump catalog used to show the pressure readings of the pumps and if they were open or closed when they did not have power to them. There were only one or two pumps that were compatible with the low pressure required for Stromberg carbs.
I can't run a mechanical pump on this engine. We've blocked the hole in the block the pushrod goes through. The carbs are Stromberg 94s, predecessor to the 97s. Looking for manufacturer/model # of suitable inline pump to serve blown, 2-carb 284 cid engine. Thanks pbsdaddy.
Merc Cruzer
Well-known member
I have one of these as a back up for my 53' Mercury, maybe it will work for you:
https://at-us-east.amazon-adsystem....up/permissions/?origin=https://www.amazon.com
https://at-us-east.amazon-adsystem....up/permissions/?origin=https://www.amazon.com