New Rookie Question about Removing 32 Engine

Her's a leveler I made, if you are a fabber kinda guy. Also good for painting. Also, put some grease on the intake gasket, then they can be easily removed and re used
 

Attachments

  • B1DF8F90-F366-402F-9A4C-D083E2085379.jpg
    B1DF8F90-F366-402F-9A4C-D083E2085379.jpg
    62.3 KB · Views: 105
Glen,


I prefer doing it without help which seems to result in noticeably fewer paint chips. But in any event, it's not a job to be rushed.
 
You need something like this. Don't forget to take pictures.
 

Attachments

  • 0125211027_Burst01.jpg
    0125211027_Burst01.jpg
    235.5 KB · Views: 75
I would recommend some guide bolts to help line up the trans to the engine take two longer bolts and cut the heads off, screw them finger tight into engine flange on opposite sides. I do put a slot in the end of the guide bolts, so a screw driver can remove them. Once you are lined up and close then just rotate the trans slightly until the spline lines up.
 
It would seem that the unique limitations of a '32 center cross member are not widely known as much of the well-meaning counsel above applies mostly to post-'32 chassis.
 
You must log in or register to reply here.
Back
Top