Gas tank filler neck
- Thread starter langus480
- Start date
Here is a description of the part offered by Snyder's:
GAS TANK FILLER SCREEN
Part # A-9020 | Model Year 28-31
This screen goes in the tank where you fill it. It is actually a flame arrestor. Won't work on the threaded version of the gas tank neck, only the tab version. Due to tab variations you will have to bend the tabs in this once you get it.
GAS TANK FILLER SCREEN
Part # A-9020 | Model Year 28-31
This screen goes in the tank where you fill it. It is actually a flame arrestor. Won't work on the threaded version of the gas tank neck, only the tab version. Due to tab variations you will have to bend the tabs in this once you get it.
Synchro909
Well-known member
I suspect you guys are talking about different things. Fuel filler neck vs filter screen.
You are correct, as the filler neck is badly corroded and I am afraid that the cap will not provide a proper seal allowing vapors to purge from the tank, especially when the outside temperature rises here in Phoenix AZ...
I would like to repair or replace the stem to provide a proper seal.
Keith True
Well-known member
The cap has to be vented,it can't airtight.The car won't run long with a sealed filler.When the gas gets hot it has to vent somewhere,unless it is leaking gas I wouldn't fool with it.If I have the windshield open I always get whiffs of gas,more so on hot days.The A is not a modern car with a sealed up fuel system.
BRENT in 10-uh-C
Well-known member
Yes, it was swaged in and the soldered with something much akin to silicon bronze. While they can be replaced, you probably need to think this through and make sure your skillset matches the task before you. If you have the resources, then by all means give it a go.
.
.
Attachments
BRENT in 10-uh-C
Well-known member
Yes, but unfortunately not at this time.