34 pickup windlace
- Thread starter elwood
- Start date
DavidG
Well-known member
It was originally made up in two sections per side with the first starting at the bottom rear edge of the cowl trim panel and then up and over the door opening to the back of the door opening. The second section starts at the top of the back of the door opening and ends at the floor directly below.
As David says front, top and rear of the door. I've done 4 32 pickups (same door openings) and have used the larger size wind lace with the hope of getting a good seal. Also always installed the rubber bottom seal. Regardless of what I did it was still noisy inside the cab.
sugarmaker
Well-known member
Elwood,
Just did this on my 32 truck. I call it a project to clean up the cab not really cut down much wind or noise. David describes the items correctly. I think you need about 10 feet per door. Btw. It was much easier on my truck, to take the tank out. Not sure of your tank configuration? I assume it's similar? Just wasn't room to work at the lower back of the door area.
Regards,
Chris
Just did this on my 32 truck. I call it a project to clean up the cab not really cut down much wind or noise. David describes the items correctly. I think you need about 10 feet per door. Btw. It was much easier on my truck, to take the tank out. Not sure of your tank configuration? I assume it's similar? Just wasn't room to work at the lower back of the door area.
Regards,
Chris
TJ
Well-known member
The tank in a pickup is under the bed vs under the seat in a truck.
Lawson Cox
Well-known member
That'd be Y'ALL.