The meter in the second photo looks like it is on some special test setting (it is hard to read in the photo) it should be on the 3 ohm range. Check it and post the reading.
The meter in the second photo looks like it is on some special test setting (it is hard to read in the photo) it should be on the 3 ohm range. Check it and post the reading.
The meter in the second photo looks like it is on some special test setting (it is hard to read in the photo) it should be on the 3 ohm range. Check it and post the reading.
Hang in the hope, you will get it.
The testing i did, was the coil and resistor out of the car individually.Well, if it is a 3.0 ohm coil you do not need a ballast resistor. No idea why you are getting strange readings. Did you try it on the 30 scale? Was the ballast resistor on car with the coil you are using? If the coil was not a 1.5 ohm coil and the ballast was connected, like Bubba said, you would think it would be misfiring or not starting. The coil over hearing you would be more like a 1.5 ohm coil without a ballast resistor. It is all very interesting.
It looks like it's reading 3 milli ohms on the 3 ohm scale so it's not far from the first. On the first setting (milli ohms), it read 2.6 milli ohms.
That coil may have a cross short in the primary winding that is reducing its normal value. The secondary was reading 13.2 kilo ohms but it has a lot more windings than the primary. It would normally be a very high resistance.
I would find a known to be good coil to check and verify meter readings. Each different brand & part number of coil will have differences and even the same part number of coil can have variances but they should be within the manufacturer's specification plus or minus percentage range. A 1.5 ohm primary coil should be pretty close to 1.5 ohms.
I'm going to change the batteries in my meter to see if there is a difference, and try again.Hope, any chance you could get someone to help you with the voltmeter readings? The condition you are describing is classic coil and/or condenser problem. They run find when cool and than fail when they get hot.