!941 Ford Coupe vent Window

A

albjerryg

Senior Member
Is it possible to have a glass cut to fill the opening of the vent window and window there by eliminating the vent window?? Sorry that is for the front and passenger door ??THANKS Jerry
 
Last edited:
I'm not sure about '41, but in'46 some models had a rear vent window that did not open. I don't know if the rubber seal is still available for these models. Check with some of the suppliers.
 
albjerryg said:
Is it possible to have a glass cut to fill the opening of the vent window and window there by eliminating the vent window?? THANKS Jerry
Click to expand...

I did this on my 49 wagon. 49 wagon rubber is not reproduced. I used some u shaped window channel which I already had from replacing the rear window channel and wrapped it around the glass.

36711752600_c2eb455410_z.jpgUntitled by philip sauber, on Flickr
 
So if I understand you put a permanent glass in the vent that use to pivot. I was thinking of a glass that would roll up and down and cover the window and vent window area? Thanks Jerry
 
If I'm reading your question correctly you want to remove the vent window and have a one piece glass. A lot of hot rodders do this, so I would ask the question on the HAMB. A couple of companies that come to mind are Specialty Power Window and Electric-Life. I don't know if your stock crank style equipment will be able to handle a larger window and you will have to fabricate a track for the front of the door.
 
You must log in or register to reply here.
Back
Top