Stop light switch fitting?

BOSSY

BOSSY

Senior Member
CAN ANYONE HELP ME WITH A FITTING TO PUT A SCREW IN TYPE STOP LIGHT SWITCH INTO A 4 PORT DUAL MASTER CYLINDER? i USED ONE SIDE FOR FRONT AND REAR BRAKE LINES AND HAS PLUGS IN THE OTHER SIDE. THE PLUG REMOVED AND A 3/16" BRAKE LINE WITH FLARE SCREWS RIGHT IN BUT THE BRAKE SWITCH IS 1/8" PIPE THREAD? i HAVE NO ROOM FOR A MECHANICAL LEVER TYPE SWITCH.
 
BOSSY said:
CAN ANYONE HELP ME WITH A FITTING TO PUT A SCREW IN TYPE STOP LIGHT SWITCH INTO A 4 PORT DUAL MASTER CYLINDER? i USED ONE SIDE FOR FRONT AND REAR BRAKE LINES AND HAS PLUGS IN THE OTHER SIDE. THE PLUG REMOVED AND A 3/16" BRAKE LINE WITH FLARE SCREWS RIGHT IN BUT THE BRAKE SWITCH IS 1/8" PIPE THREAD? i HAVE NO ROOM FOR A MECHANICAL LEVER TYPE SWITCH.
Click to expand...
I'll look tomorrow and see what i got? ken ct.:)
 
best way to go is put one of those mechanal lever type.there much more sencetive & dot 5 can,t hert it. ez to mount on the toe board. the sligest tuch lights the brake lights giveing the car behind you a warning that your going to stop sooner than a hydl. one
 
Are you looking brake switch for a inverted flare? If so Speedway #910-31303 it's 3/8-24 $14.99 or 3/8-24 IFF to 1/8 MPT male # 910-31831 $2.99
 
Last edited:
I remember trying to do this exact same thing, went nuts trying to find the fitting, put in a tee in the line in a spot where I can get at the switch, I change them every 3 years good or bad, I just do. I found a tee with the tap on the bull.
 
You must log in or register to reply here.
Back
Top