columbia ?

[trike84]

Can you run a 42-48 shift solenoid on 12 volt, being that it is a momentary connection.

 

[G.M.]

I would run the hot wire through a resistor. G.M.

 

[trike84]

I have a new ballast resistor part # D1110-A, for a corvette, is this compatible?

 

[trainguy]

I doubt that a ballest resister will carry the current.I would try the resister designed for heaters or radios. Phil

 

[G.M.]

I have a new ballast resistor part # D1110-A, for a corvette, is this compatible?

Try it and see how hot it gets. G.M.

 

[Kurt in NJ]

Measure how many ohms the solenoid on the columbia control has, find a ballast resistor that has the same ohms ---use that ---the columbia solenoids are not designed to have power to them all the time --just momentary while the clutch is down,

The first generation mopar electronic ignition has a dual ballast resistor ---one or both of them can be used ---series for more ohms ---I have used these to fake out lamp modules when led lightsare retrofitted

 

[trike84]

tried a echlin ( napa) VT-6184 12-6 volt reducer, 12.2 volt in 12.2 volts out. does a volt reducer actualy drop voltage or just adjust ohm's.

 

[Kurt in NJ]

Only when it is under load will you see a change in voltage, in an open circuit there will be no reduction in voltage

 

[rotorwrench]

You have to measure voltage across the resistor. It will always show system voltage at the output end but will measure correct voltage across the resistor.