29 tudor cowl & ccpu rear section

[charles=fla]

any one have the deminsions of a 29 ccpu door, side to side top to bottom, and center line of hinges, from bottom to 1st one, then to 2nd then to 3rd then to top of door..or..can i make a ccpu using a cowl from a 29 2dr sedan?..thank you..charles..)..

 

[Steve Plucker]

The cowl sections are different, at least the upper windshield header peice is.

Pluck

 

[Purdy Swoft]

any one have the deminsions of a 29 ccpu door, side to side top to bottom, and center line of hinges, from bottom to 1st one, then to 2nd then to 3rd then to top of door..or..can i make a ccpu using a cowl from a 29 2dr sedan?..thank you..charles..)..

No!

 

[Dennis Pereira]

any one have the deminsions of a 29 ccpu door, side to side top to bottom, and center line of hinges, from bottom to 1st one, then to 2nd then to 3rd then to top of door..or..can i make a ccpu using a cowl from a 29 2dr sedan?..thank you..charles..)..

these are close with bad light top 29 1/8'' bottom 29 1/16'' rear 48'' front 46 7/8 '' center line to bottom hinge 9'' center 25 7/8 top 42 1/8 and 5'' from center of top hinge to top of door. Disclaimer this measurement's were done without my reading glasses. have fun charles

 

[Dennis Pereira]

these are close with bad light top 29 1/8'' bottom 29 1/16'' rear 48'' front 46 7/8 '' center line to bottom hinge 9'' center 25 7/8 top 42 1/8 and 5'' from center of top hinge to top of door. Disclaimer this measurement's were done without my reading glasses. have fun charles

Also the door pillar cowl post lengths are different measured off splash coupe 43 3/4'' p/u 47 1/2''

 

[charles=fla]

thanks for the information..i really dont neede another project..charles..)..