Search results

1963 Ford Falcon 2 door hardtop 10k or best offer. 260 V8 - T10 4speed. Running registered project car. New quarters, floors and trunk. Will drive 200 mile round trips without a sweat. I'll listen to all offers and trade ideas. Thanks for looking - John

30/31 steering column with I think is a 32 - 34 steering box. Was in my coupe until I switched out for an F1. $125.00 local pickup only. Thanks

Bought part from a fellow Barn member. I'm all set.

Re: MA9 cap on Mallory YC For people that may be searching just wanted to update this thread with the MA9 cap ($83.00) on a Mallory YC distributor. Exact replacement with the MA7 ($21.00) rotor.

63 Falcon Z bar - no longer needed Found one at a low price - no longer needed. Looking for the Z bar or equalizer bar for early sixties Falcon.

bump

bump

bump

bump

1936 Ford Radiator SOLD About a year ago I had a local radiator shop fix a leak, and then ran this at low pressure on my 8ba test stand. So it doesn't leak. Local pickup only

8ba fan $25.

1939-48 Ford front backing plates. $50.

8ba bell housing $75.

8ba exhaust manifolds $50.

35 Ford 16" wheels. $50.00 each... Sale Pending

New Moog front springs, upper and lower control arms, shocks and strut rod bushings. Also new Dayton USA made rear six leaf springs. Price increase is for parts only, the labor is FREE. Starting drivers sider floor next.

1963 Ford Falcon Futura - 260 V8 Auto. Starts, stops and yard drives - no exhaust. Open Maryland title. Sub rails are solid, the trunk floor has holes. I just installed passenger side full length floor pan and have the drivers side but haven't started installing it yet. I'm including a...

Re: Holley 94 on 8ba barely runs * Resolved * After several hours of troubleshooting and research (here and elsewhere) I found the cause of my hesitation and lack of power. It was worn insulation on the hot wire under my breaker plate. I wasn't able to see it until I completely disassembled the...

Yes I'm using compressed air. I did check for leaks with carb clean and didn't notice any difference. Vacuum readings idling is almost 18" so if there's a leak its a very small one.

Thanks Ron! I'll give this a try over the weekend.