Search results

Thanks for the info. Is there any kind of backing or frame. Or is it just upholstered springs hooking on back and floor?

Iis there any frame on the back and seat of the 36 roadster? Or do the springs mount directly to the metal?

Looking for 1936 Ford Roadster sill plates. Please PM me. Thanks

Looking for a pair of good 1936 front shocks

What bolts were used to bolt through the floor pan to the angled part of the frame? They are 5/16" fine thread, go into cage nuts, but what head do they have? Was the B pillar riveted to the floor pan originally? Kinda looks like 2 - 1/4" rivets in each pilar at bottom foot. Thanks for all your...

Has anyone heard anything about Paul? Talked to him 2-3 mos. ago. Was suppose to receive riser for '36 that was ready to ship. Tried to call, phones have been disconnected. Hope nothing has happened.

Thanks Guys for all the info. Had the die in my box. Worked great. Another step forward. Thanks again.

Hi Again Guys, I have a 1937 steering box I'm installing on a 36. Rebuilding it now. 1st couple threads were smashed when I took the nut off the steering sector shaft it turned the threads bigger than the original. would like to rethread. I have another nut. Wondering if anybody knows thread...

Thanks David, I can only dream, that my 36 will look as good as yours. But I keep on plugging away.

Thanks Guys. No I dont have the toe board installed. Frame off restoration. Couldn't find any other number on brake ar. Bends slightly to left then goes straight. I'll try and post a picture tomorrow. Thanks for the info,

Hi Guys, I need help. First time build. 36 roadster brake pedal hits frame when it returns. Don't think this is right. The brake arm only has a M3 on it. The clutch has 48-7520-A2. Are these the right arms? I sur would appreciate any hep you can give me. Thanks in advance

Thanks guys I appreciate it.

Another newbie question. Ready to install new cam bearings, 1936 221ci. Does the big oil hole or small oil hole in the bearing , mate with the hole in the block? Rear bearing only has 1 hole. Thanks in advance.

Will do. Thanks to all.

Sorry for the repeat. New at this.

Thanks for all the help guys. I'm pretty finicky too. Got books recommended by guys on FordBarn. Just couldn't find .030 under/ standard bearings. Is it ok to use 3 different brands, pairs match, if they are fitted properly? Ron is Nax VP a member? Can't find him. Thanks again.

Thanks for all the help. I'm pretty finicky too. Got good books recommended by guys on FordBarn. Just couldn't find .030 under/ standards. Ron, who is Nax VP, cant find him.

New to the flathead scene. Anyone's help is appreciated. Engine has been rebuilt previously. Engine was balanced and sleeved. If I bore connecting rods to .010 over will that throw off the engine balance.Looking for .030 oversize rod flanged bearings with standard OD for 21 stud 85 hp engine...

Any luck on 36 front end?

Thanks guys for your help. Now I need to know the measurement difference between a '36 & '37 up. Where do I measure & what's the measurements. Thanks Loads . I'm learning!!