Search results

I need a RH upper door moulding for a '48 Ford convert.- Thanks Ford Barn

Thanks Ggmac- I'll have this in in no time- R Sullivan

Hi gents- I'm installing a new trunk light extension wire in my '48 Ford convert. Where should this wire enter the trunk? I have replaced the floor pan. Thanks, R Sullivan

Is my new headlight cross over wire routed behind or in front of the radiator? Thanks for the help. This is a '48 Ford-

I am installing the headlight crossover wire on my '48 Ford. Does this go in front of the radiator? Thanks for the help.

Kube- thanks for the info, as soon as I read I remembered how the fenders came off.

Hi gents- how are the nuts, bolts, and washers installed on my "48 ford rear fender? Is the flat washer and bolt pushed up from the wheel well?

Hi gents- how are the bolts and washers installed on my '48 ford rear fenders?

Ford 8ba engine-turns, always stored indoors, ran when stored.

Ford frame-'42-'48 good condition, surface rust- no pitting

Hi gents- I've misplaced the two firewall clips on my '48 ford for my choke and throttle cables- can anyone help? Thanks, R Sullivan

Hi gents- The stainless trim on my '48 Ford dash appears to have glued on fasteners- has anyone replaced these? Would JB weld be a good bet? Thanks, R Sullivan

I need a body mount as shown-the left and right mounts are different- (mirror image)

Hi gents- Does anyone have a website for ordering dash woodgraining components? Thanks for the help.

Hi gents- I'm having trouble installing new parking brake cables on my '48 ford. The rear cable (loop) will not pull forward enough to fasten to the front cable. Any ideas?

Hi gents- I've just installed a flathead and drive train in my '48 frame. What minimum temporary wiring do I need to start this thing?

Hi Barners- I have both the high step and low step mounts for my '48 Ford- which are correct?

Hi Gents- I'm converting a '46 frame to '48 tube shocks. I'd like to know the distance, in inches, between the upper rear mounting studs,and are they parallel to the centerline of the frame? Thanks in advance, R Sullivan Mi.

John- Thanks, Good explanation- I'll have this thing apart in no time. Maybe.

Hi Gents- I'm having trouble removing the pin in the drive shaft where it connects with the banjo assembly. This is a '48 Ford with the torque tube. Are these tough to remove? Thanks, R Sullivan