Search results

Hello All: I have done alot of searching, thought somebody might have a definitive hard number that would save a bunch of measuring: What should the Fuel Pump pushrod length be for an Edelbrock Slingshot on an 8ba with the 8ba Fuel Pump? Already have crankcase ventilation set up w PCV and...

Thanks for the input guys

Has anyone had any issues running an Optima with a Generator (Charging Issues??)

Ah- thank you!

Thanks Pete, that's the one I have- no charging issues from your experience??

Hello All: Posted this over on the HAMB too (got some good insight, just wanting to see if anyone here has ever actually run one)- has anybody used the Odyssey PC680 w a generator (12V)?? If so, any issues?? Thanks in Advance, Dave

Very nice Edmunds intake w 2 very nice Stromberg 81's. Pulled this off of my running car a few years back, I would go through the carbs. They are move freely and are very clean. Includes linkage and fittings as shown. $750 Best, Dave

Very nice patina- $95 shipped to lower 48. Thx! Dave

Hello All- in looking under my 34 project, it looks like the bolt and nut attaching the radius rods to the torque tube are incorrect (no cotter pin). I have the correct bolt, nut, and cotter pin- my question is, how tight when I switch fasteners?? Thanks! Dave

Got it!! Thank you- I missed that when I was looking. On its way.

Whelp, I thought I had everything perfectly planned, my Flathead newbie status was just exposed. It appears as though the I have a long snout cam and my 2 bolt timing cover won’t allow the distributor to index properly. I don’t want to swap cams. I guess I can put a 3 bolt cover on it, and use...

I have a few to choose from, good eye- the edelbrock regular dual does well at placing the carbs over the intake ports, but I may run my Navarro reg dual. I haven’t decided yet.

Thx Mart!

Thanks very much guys- I’ve read a lot about vacuum brake no vacuum brake- I know Bubbas had indicated it should be used. Makes sense that the higher octane/ low compression reality renders the advance brake not necessary. Thanks Again!

Drake pumps, sealed bearings- no need to seal extra hole up top in block (water pump). Correct 59a Cam gears for proper thrust Holes in block sealed with welch plugs Not sealing the pan- going to run a pcv setup in the road draft hole in the intake to vacuum (in the intake). Did you come...

pcv

Thanks- yes, the manifold is an edelbrock regular dual, it does have a port under the back carb, I’m sure I will have to make some stuff to get it all sorted. Really just wanted to make sure I get the correct fittings.

Great, thanks-I will give them a shout tomorrow- yes, I understand vacuum signal comes from manifold, not the other way around😀

Hello All: I just want to make sure I have my ducks in a row- I have dressed the front of my 8ba with early pumps, cam, 2 bolt timing cover, pulley, etc. I am going to run a stock rebuilt crab distributor, w vacuum brake. I need to run vacuum to the manifold from the timing cover, what is the...

I found one, thanks guys