Search results

Top half warped I used two gaskets and it took care of the leak on the one that i had Sent from my iPhone using Tapatalk

Look at early mustangs I have one in mine but can’t remember the model id was supposed to fit Did a lot of looking to find it Sent from my iPhone using Tapatalk

Brother inlaw has a 30 that was rebuilt in the 1950’s by sears and roebuck company And it had a spot on the side of the block that had been fixed So yes it’s very possible Sent from my iPhone using Tapatalk

You might want to check for intake leak if u have a backfire going on I had what sounds like the same issue and it was intake sucking air by the gasket Merry Christmas and good luck[emoji1374] Sent from my iPhone using Tapatalk

Over thinking it It vents up thru the torque tube as long as u are still running it If you are running a open drive shaft Then yrs you will need an external vent Sent from my iPhone using Tapatalk

Comman sense It’s not rocket science Unless you’re going to use the oem shock mounts Cut them off and run the backing plates straight up as they were designed End off issues Just saying Sent from my iPhone using Tapatalk

nice

Why not use a timing light and start playing with it so when your lever is all the down it will only advance as high as 28 Not that hard to do Sent from my iPhone using Tapatalk

[emoji106][emoji106][emoji106][emoji106][emoji3059][emoji3059] Sent from my iPhone using Tapatalk

Depends on what ignition you are running Sent from my iPhone using Tapatalk

I use a steele other than the magnet on the back of your phone all the time it is great for holding any phone,have one in all my vehicles Sent from my iPhone using Tapatalk

Bad ground probably on the steering column Sent from my iPhone using Tapatalk

Sounds like mine under load when not warmed up yet Hasn’t hurt anything yet, had it all apart this past winter and found nothing out of the ordinary, put it back together and it still makes the noise Beginning to wonder if it’s moisture related, bottom of intake has a lot moisture dripping off...

I used E-85 gas Sent from my iPhone using Tapatalk

Put a small bottle of K Seal in it if it’s not coming out the over flow k seal will take. Care of what ever leak you may have it is great stuff little pricy but worth it Sent from my iPhone using Tapatalk

Meant to say have not had any leaks Sent from my iPhone using Tapatalk

I didn't like the way mine fit so i just brazed mine in place Good to go ,and now i don't need to be concerned about it!

Sent from my iPhone using Tapatalk

Heres one Sent from my iPhone using Tapatalk

I will try later today Terry