Search results

Thanks Ronnie, that's what I thought.

I know a lot of discussion has taken place about spark plugs and Aluminum after market heads but I have not been able to find an answer to my specific problem. I have Navarro heads from H&H Flatheads on a 1950 8BA V8 with an L-100 cam (.375 lift). H&H recommends Autolite 216 spark plugs for...

Thanks glennpm.

37 truck, where does the Limeworks kit move the wire to? It seems like my wire in the steering column is the tidiest way handle the ground.

Glennpm can you tell me who carries a horn wire repair kit?

Thanks rich b, I'll check with Limeworks tomorrow and see what they recommend.

Thanks fordor41 I might do that. I was hoping someone else had encountered this problem and would share their solution.

I'm installing a banjo steering wheel from Limeworks and have run into a horn button wiring issue. The steering wheel is second hand and I have no installation instructions. I've attached a picture of my horn button setup. I know that the wire in the steering column is not attached to the...

Thanks for the input guys. I talked to Speedway and they said they hadn't encountered my problem before. They advised shaving the outside edge a little to gain some relief.

Newc, thanks for the response, the spindles (https://www.speedwaymotors.com/Speedway-1928-1948-Ford-Milled-Forged-Spindles-w-King-Pins,352717.html) and bearing kit (https://www.speedwaymotors.com/Wheel-Bearing-Kit-for-Early-Ford-Front-Hubs,31648.html) are brand new and are claimed by...

Installed the speedway Bendix Style Brakes for 1937-48 Ford Spindles recently and am having grinding problems. This is a new build and all front end components are brand new. Whenever I apply anything greater than mild braking I get a grinding sound from the driver's side brakes. When I removed...

FOUND ONE, THANKS FOR LOOKING. Need to replace my current 19 tooth speedometer drive and housing with a 17 tooth gear and 18 tooth housing. I've located the 17 tooth gear (Bratton's) but need a 18 tooth housing like the one in the pic, as my 19 will not work. If you have one for sale let me...

Found one from Yankee Mike here on the Barn. Thanks Looking for 1932 Ford pitman arm for car. Prefer one with good splines and reasonable price. TIA Tony

I got a hold of barnfind 08 and have two NOS Ford axle nuts on the way. Thanks for the help and information. Tony

Thanks guys, I've sent a message to Barnfind08.

Thanks Ozyrodder, I'll give them a call in the morning and see what they say. Tony

Looking for a source of hardened axle nuts for a 1940 rear axle. I was installing the rear driver's side hub when I went to torque the axle nut to 200 ft/lbs. the nut stripped. I only got to 175 ft/lbs when the nut began to turn. These are brand new nuts from one of the vendors many of us use...

Hi, like everyone else I am looking for a stainless 1930/31 Cowl Band for a Coupe. TIA.

Thanks for the info guys.

rich b, I’m going to you use the radio power wire on pin 30 since I won’t be running a radio. I’ll be sure to fuse it. Earlier you mentioned a ballast resistor on the coil circuit; if I’m running a ballast coil would you still recommend adding a ballast resistor? Thanks again I really appreciate...