Search results

Thank you

On a 59AB block with an 8BA crank with insert rod bearings Should I use torque specs for the 59AB mains 80 - 90 ft/lbs & 8BA torque specs for the rods? 45-50 ft/lbs Mains per Mac Van Pelts page 32-48 V8 - 80-90 ft/lbs 49-53 V8 - 95-105 ft/lbs Rods per Mac 32-48 V8 - 40-45 ft/lbs (self locking)...

It is a 59A I think, here are a couple of photos

The engine is a 1947 59A

The oil pump in my engine has the pick up tube mounting bolts in line with the oil pump. The pumps I've seen for sale now have the pick up tube bolts mounting to the pump diagonally. Plus the pick up tube is bent in a way that isn't like any of the new pick up tubes I've seen. Does anyone know...

I have no idea what the person was thinking when they did that, the pulley was like that when I received the engine. I am in need of a correct pulley for a 59A engine if someone has one they would sell. Thank you all for the replies.

I need a Crankshaft pulley for a 59AB engine.

What crankshaft pulley do I need for a 1947 59A block with a EAB crankshaft? I recently bought an engine that came with a crank pulley that doesn't line up with the water pumps.

Update #2 I have installed a 50 lb. oil pressure sender from Kaiser Willys Auto Supply, part number 800807 using a 1/4" NPT to 1/8" NPT reducer bushing. The gauge is working properly now.

Here is my update. I bought a new sender from Dennis Carpenter. It reads 0 regardless of the RPM, without any teflon tape. The previous unit from C&G went off the scale high. I grounded the wire temporarily with the Carpenter unit & the gauge immediately reacted, but went back to zero when...

Re: 59AB in 35 ford maxing out oil pressure gauge I have a mechanical gauge that I wanted to try but unfortunately I can't find it. I've ordered another sending unit from Carpenter. I would guess the one I bought from C & G was probably made by Carpenter too.

It reads 0 with the key off 5 lbs with the key on not running maxs out past 50 while running at an idle I don't know if it has a pressure relief in the pump. It's still 6V pos ground I bought the truck last year. It didn't have an oil pressure gauge or sender. I bought a dual gauge set up oil...

I have a 59AB in a 35 Ford truck with a oil pressure/fuel gauge in it. It maxs out over 50 lbs at an idle. I have a new 50 lb sender from C&G What would cause this. Possibly a defective sender???

I'm looking for a 1936 oil pressure/fuel gauge set Thank you

Thanks for the replies, I used a small bent screwdriver to pry off the caps.

How do you disassemble the trunk hinges on a 35 coupe? On the inside there appears a tab locking the hinge pin in place. I would like to remove the pin.

Great information! Thank you!

Thank you!!

Thanks!

Where does the crossover wiring for the passenger side taillight go? Does it go through the body (interior) of the car or behind the gas tank under the body. Thanks, Daryl