Search results

Very nice article,Tom. Thank You;

I did the top water outlet housing with the tapping for the temperature probe. It works impressively well.

When I bought my Model A, one side of the rear axle had a "REX A " carbon steel tool bit for a key. It had been used as a lathe tool. When we disassembled the rear axle and housing, we were faced with an entire rebuild including axles. What a mess;

Well....I built my own trunk from plywood, covered with fake leather. I attached it to the rack today.

I built a trunk, and the chairs and tools, and some spare parts. Regards;

Awesome; thank YOU ALL for your responses. Thank You;

I've installed a Marvel Shaber carburetor. When I idle with the spark fully retarted, I get a real nice low idle. Maybe to slow?? I notice the ampmeter goes from a slight charge to a slight discharge. I do have the generator lookalike alternator (Powermaster). With the spark advanced 1/4 way...

Rusty: Use a screwdriver and remove the "top hat looking" cover. The shaft can be pulled out with needle nose pliers. Good Luck;

Awesome; Thank You

So, I am so fortunate that my wife bought me my first set of 3X spark plugs. My question is, the copper washers are cupped. Does the cup face the plug, or the cylinder head. Another words u or n? Thank You;

I had a similar problem. I found that while I was double clutching for first to second, I would move the shifter from right to left (in the middle) a couple of times, and then go to second. It only happened from first to second. It has since worked itself out. I think mine was a little...

Best I have

Finished

I've been there. Good Luck. It is entirely possible to save. Good Luck;

Briggs town sedan

I had chatter that was awful. My flywheel was perfect. My pressure plate was 0.035 out of flatness. I changed the pressure plate, pilot bearing, and clutch disk. It is as smooth as silk now. Good Luck.

You can use the Rotella T Triple Protection 15W-40 especially for older engines with flat tappets because this motor oil has 1200 ppm of zinc for more wear protection. I hope this helps. Best regards, Kevin Shell Technical Help Desk - US

In Massachusetts, a title is required, however I purchased a car without a title. I had the police come to my house, they checked the serial number, and provided me a document to go with my bill of sale, to bring with me to the DMV. The DMV collected sales tax based on a table the state has...

I have the high boy, and I am very satisfied. I had a Zenith 2 and now I have a Marvel which works super. Good Luck;

The inspection station I go to in Massachusetts looks at lights, horn, wiper operation, tire tread and overall appearance to evaluate condition. They also have to drive it in and out of the inspection bay. They do check the brakes in the parking break during the drive-in and return to the...