Search results

Alan - Thanks - I think that I have it figured out. Also - in reviewing past posts - it appears as if you may have answered a similar question a year ago. Once again - many thanks. rich

Alan - Thanks. I went back to Forum - then - V8 - then searched the thread - and - found your reply. I'll take a picture - and post it - to make sure I'm understanding what your're telling me. Also - am I correct in my understanding that the 37 was the last year for the hot air heater and...

Alan - I see your reply - but - don't see anything when I scroll down. I'll keep looking - thanks. Rich

Howdy! My Big Truck came without a hot water heater. My engine is a 85 HP - 24 Stud - Flathead. Where are the water ports from which I can fun the hot water hose for the heater? Many Thanks. Rich p.s. I do have s Southwind Heater - but - don't want to drill any holes into my Chandler...

Howdy! I'd like to install a 1938 correct aftermarket hot water heater in my truck - and - would welcome whatever information and suggestions any of you might be able to provide - such as placement and installation. My truck did not previously have a heater installed. Many thanks. Rich

Thanks for your reply. I suspect that I'd have to do remove a section - but - wanted to ask someone else first. Have a great day. Rich

I need some expert advice here. I've picked up a 1938 horn rod for my big truck - but - it appears to be somewhere about three or four inches too long - which leads me to believe that the horn rod for the big trucks was shorter than the horn rods for the smaller trucks and passenger vehicles...

I have a Horn Rod for a 1938 1 1/2 Ton Truck that is "mangled." Does anyone know of someone who might be able to restore this for me? Thanks for any and all ideas. Rich

Does anyone know a source for a Horn Rod with Horn Switch fo a 1938 Truck - 1 1/2 Ton? Thanks. Rich

Many thanks. I believe that the diagramin the green bible is for a 1940 truck - but - not a 1938. I don't know how similar or different they are. I will check Vanpelt Sales - thanks. Rich

Does anyone have diagram for either the steering assembly or wiring harness for a 1938 Ford 1 1/2 Ton Truck? Also - recommendations as to how best mount turn signals would be most welcome. Thanks in advance. Rich

Howdy! I hope that some of you knowledgable folks can help me. I'm restoring a 1938 Ford 1 1/2 Ton Truck - a ten year project already. I've found an oil filter canister - but - some folks are telling me that it is more trouble than it is worth - but - I'm somewhat skeptical - since - I've...

I'm looking for a part for my 1938 Ford 1 ½ Ton Truck. I need a Small Gear (Carrier) Case - 10155 for my Eaton Two Speed Rear Axle - Identification Number: 101611E S2929. Thanks to all who responded previously - I did find all of the parts I need (except for the small gear case) from Job...

Sorry for not having responded sooner. I just saw your post. I live in Arizona. Rich

Thanks. Sorry for not having responded sooner - I just saw your post. I'll phone Chuck. Rich

Thanks. Sorry for not having responded sooner - I just saw your post. James at JobLot was most helpful. He had everything I needed except for the "Small Carrier Case." Rich

I'm restoring a 1938 Ford Big Truck - and - need some parts to rebuild the Eaton Two Speed Rear Axle. If someone could recommend a source for the Small (Gear) Carrier Case plus bearings - I would very much appreciate it. The Axle Number is 101611E S2929. Thanks. Rich