Search results

I have been in this type of predicament before but by dropping a nut down the air intake of a large diesel engine. I was very lucky to retrieve the nut ( 1/4" ) which had dropped a long ways into the motor. I went to the store and got two large packs of " Double Bubble" chewing gum. Knawed on...

So... To recipricate to the generosity of the "Barn" members. I have the following to offer for FREE to anyone in need. -55' BW T98(?) 4speed syncro transmission. not for flathead I believe. From a bus -55' Dually 2 speed rear end, 12volt, with wheels and old tires. From a bus -Not sure of year...

found one, thanks

Well, I have been rescued of my CRS, the den of antiquity and black hole, inner sanctom of my shop by "Flatrod" up in Alaska. He is generously sending me the brake pawl that I am in need of. This transaction goes to show all that the "Barn" community has a large number of big hearted...

Flatrod, Thanks that would be much appreciated. I'll PM you.

Anyone have P/N 51-2786? It's the small, toothed pawl at the bottom of the parking brake handle. 1950 F5 COE I will buy a complete parking brake handle if it comes to that.

Anyone have P/N 51-2786? It's the small, toothed pawl at the bottom of the parking brake handle. 1950 F5 COE I will buy a complete parking brake handle if it comes to that. Duh! this should be in the wanted section

Anyone have an idea where to source one? Part number 51-2786 I would even purchase a complete parking brake handle. I will ask in the want ads also. thanks.

We have probably all done it. You take something apart for for repair or refurbishment and then set an important small part in a "safe" place so you will never lose it......never to be seen again! I confess. I have misplaced a small part to my 50' F5 COE parking brake hand lever. Its the...

Thank you Bob for the diagram and photos. And thank you Pete for the enlargements. I believe that I do have a couple parts specific for the COE application. Maybe "Number Dummy" can help out with a COE parking brake diagram....?

I am back working on my 50' F5 COE after a few years hiatus. Can anyone provide me diagrams and or photos of the the parking brake assembly and linkage. The factory manual is not particularly clear to me. I have all the parts cleaned and prepared for reassembly. Thanks

I can probably punch one out of the back of my partner’s boiled wool hat! She may not notice for awhile.�� Made one for the dipstick from the tongue of my old leather work boot! Thanks again.

Thank you Kube for the explanation… I think I can understand it! Lol Best regards.

Kube, Thank you for your definition. Do you know what the dimensions of the authentic dense wool seal? I have some material that would be appropriate and can punch one out. I have always appreciated your precise explanations here on the “Barn”. Regards.

Thanks, So it is to seal the connection between the ball and the cup of the equalizer shaft?

Can anyone tell me where part# 7539 rubber washer is located on or near the clutch equilizer shaft? I’ve seen in the parts drawings but don’t remember how it is installed. Thanks!

The best door locks you can afford!

Need a pair of good used rear axles for a 31 A. Anyone in NW Washington state have some?

Katy, Thanks for the reminder. I will be inspecting all internal components. Bearings, gears, ect.. Then onto brakes on all four corners. best regards

Thanks Brent, Sounds pretty straight forward. Hopefully I can source a pair of good used axles nearby. Best regards.