Search results

Thank You, do the fellows work and/or sell 32 Zenith "B" carbs. That would be helpful I need some work on one of My Bs Carb Thanks Hugh

THanks to All I will try the Distributor Body Thanks to all, Hugh

Hi Ayers! Thanks Do you know Wayne on Waynesboro If you do, Tell Wayne From Waynesboro Hugh Said Howry , I live in Clarksville VA Thanks Hugh

#3 Cylinder has a Skip when running. I changed plugs. Still have a Skip No water in The Oil, and No Oil in the water. Any suggestions on what might Be the skip when engine is running Thanks, HS

Patrick Thank You. I have spinned Drivers side, good only a Very Faint drag. Passenger side spins good no drag at all. Going back out for another test run. Hugh

Howdy, I have adjusted my front brakes. Out on a test drive, I did some panic stops, the car stops great but the drums seem pretty hot. (150 degrees) I have cast iron drums. I'm using a Digital Thermometer check the Drums after a test stops. My question is How hot is too hot...

Thank You Blockhead. Do you pull the Cable out from the Speedometer First -- do you have to remove the Speedometer body from the Dash plate? Hugh

Brent, I have a Mitchell Overdrive. How does that effect the Greasing of the speedometer cable Thanks Hugh

THank You for your reply. OK Hugh

Hi Brent, I thought that we should use Graft-ite?? and not grease?? Thanks for you reply! Hugh

A couple of days ago, I noticed the speedometer in my 28 Phaeton swinging wildly between 0 to 30 as I was first driving out my gravel driveway slowly in first gear. By the time I got to the paved road (about two tenths of a mile) and increasing my speed with pressure on the gas pedal , the...

Brent, Thank You for your Time. Looks to me that both King Pins are the same? I did see an "R" on one King Pin. I assume that is for the Right side-- No marking on the other King Pin.

Hi Brent, Ref: Your post of back to me Yesterday, How do a tell the difference of the Right and Left King Pins? HM? Thanks, Hugh

Yes I have the Nut on the Locking pin

Thanks, Brent. My Lockings pin On the Right side / Passenger side, is stcuk, I have been beating the Locking pin with a good size hammer-- No Luck Yet?! Hugh

Just wondering, are the New Kings pins we buy from our Vendors Maked at all as "Left" and or "Right"? I have a older repro and only One of the King Pins are marked with a "(R) is that the case on all King Pins, Oh MY drivers side locking pin is in there Tight/Tight may be stuck? Not...

Vin Tin , I was thinking about using smaller size wood screws, in the inner belt rail That way they should be easier to Put in and To Take out . Thanks, Hugh

Vin, Tin Thanks, Can you take some pictures of your Belt both Inner and Outer and Post. How in the world did you get this off the wooden Belt rail? with 1 1/4" small body Nails. AS you how Im going to get the Outer rail to snap on the Inner rail--Having Not done this before, I have no...

700RPM Thank You, Im still Not sure on how to attach the "inner" Metal belt rail to the wood belt Rail, small body Nails or small wood screws??? Thanks, Hugh

I need some help. How do I attach the Metal Belt rail on to my 1929 Sport Rail. The inside /Anchor Belt rail has small holes drilled every 1 inch or so. That will hold the outside metal belt Rail that will snaps into place. I assume that these small holes hold the inside/Anchor Belt rail...