Search results

Best composite gasket on mine. .125 over

I have one at .125 . Runs like a watch.

Looking to buy a high compression head . Brand not important. Aluminum or Cast Iron. Message with what you have and price. thanks

I am listing this car for a friend of mine. It is a nice driver and an older restoration. Runs and drives very smooth and looks great. Many recent upgrades to include 6 v alternator, brakes, steering box, tires, and new manifold. I'm sure there is more- he has owned for 10+ years. If...

I have a complete flathead from a low mile 1953 F100 panel truck. I have no idea of the motors condition and would assume it seized? The bell housing is attached; which was for a 3 speed on the column trans. Best offer on anything or everything. Try me as it will be headed to the scrap yard...

Marc - I am in centerville on weekends only. I have a head puller. I can help but not until the weekend. Call my cell 508-726-2579

Bump

Bump

I have an unused fully rebuilt AER touring motor. It's a full insert, counter balanced crank, larger valves with a Stipe 330 cam. It has never been removed from crate/plastic. I bought this last year and my plans for car have changed. I have nearly 3,600 into this engine alone with shipping...

I guess that's a pretty fair answer! A neat set up.

What's that make for HP?

Are the ones shown in picture MG bearings? As in the car MG?

George -Who is AI that has the better bearings?

X2 on piston clearance. Especially on #4.

I will give him a call. Thanks

I have what I believe to be a Mallory electronic distributor. Im looking for the hold down device that clamps around dist. Shaft and then sits in the head with a pin. Anyone know where I can get the right one?. I'm afraid if I just use the set screw - the dist. Will walk on me- throwing it...

The cracks shown by J and M are nearly identical to where my housing was cracked. Couldn't see them until magna fluxed

Re: Flywheel housing question-Update Followed HERM's advice and was able to get it within .001 at top and both sides. The bottom is still out about .020. But I believe ****** will pull that in. One note I wanted to mention - I would have sworn the housing was in nice shape and not cracked. I...

Thanks for the input. I spoke with Herm today and I am on the right path.

I've read just about every post regarding how to align the housing . I know you should have no more than .006 between the 12, 3, and 9 o'clock positions. Here is my million dollar question: Once you bolt the housing to the trans- aren't all these tolerances going to change? Won't bolting the...