Search results

Flathead Engine, Midnight Blue, New Upholstery and Headliner. Completely Restored from Rust-free California Vehicle. Upgrades: 12- Volt Electrical System, Electric Fuel Pump, Pointless Ignition System, Dual Exhaust. Beautiful matching, midnight blue bed liner. Registered and Road Ready...

Wanted 46-48 Ford car grille or bars. THX Dave

Need right Pass side top hood section for 1929 Model A. Thank you,

I recently obtained a 55 with a Yblock V8 272? The oil filter housing is about 2.5 inches in diameter which is smaller then all filters listed for Y blocks. My question is has any fellow barner encountered this and knows of a source for filter cartridges or filter number. Thank you barn 40dave

Can one of you barners help with installation information and perhaps provide photos. I,m trying to install the wooden header on 1928 Model A two door. THX 40dave

Best offers Takes them

Have a complete 1947 Ford Frame/chassis (no engine) has entire drive line, transmission, rear end, tires, wheels, brakes, steering, tie rods, etc, $800 takes all. Or will part out. Also, have a steering column,includes box with ignition switch, key with nice steering wheel and horn ring. $150...

Rolling 1947 Ford Frame, with wheels, transmission and complete drive line. $500 Also, have heater in good condition $ 100 and complete steering column with steering wheel,horn ring, ignition lock and key. $360

I just turned 25x3. However, my trucks a few months older and still going strong

Want to buy 1947/48 FORD front, rear fender molding and grill trim. surferdaveca@yahoo.com THX Dave

Want to buy body Molding for 1947/48 Ford coupe/sedan. THX Dave

Want to buy 1946 Ford glove box Trim with V8 emblem. THX Dave

Have you sold the trunk handle? THX Dave

Want to buy 1940 or 1941 Ford 1/2 ton pickup. Email me @ surferdaveca@yahoo.com THX Dave

Perry, Please email me regarding the forty pickup. We have done business before via the barn. Surferdaveca@yahoo.com THX Dave

Looking for left outside rear view mirror that threads directly into upper hinge, not type atached with hinge pins. THX Dave

Have you sold the side molding and cowl miirors? THX Dave Surferdaveca@yahoo.com

WTB 1947 Ford windshield wiper arms that go from motor to towers. Would also consider an entire electric wiper set up for 12 Volts. THX Barners, Dave

Great Information! Thanks Guys

This may seem like a stupid question, but I'm going to ask it anyawy. Should gas flow freely from the tank of my forty pickup when I disconnect the fuel line close to it? (8 to 10") I've had reocurring fuel problems and noticed that there was little or no fuel flow from the tank while...