Search results

I have the radiator and shroud all attached. the hood on and working to adjust the front of the body height so that the hood fits good. the problem I'm having is I have to raise the body up more than half an inch to get the hood to fit correctly what is the max i can raise the front of the...

I've just set my body on the frame and also have all the other sheet metal bolted together. Now I need to start shimming and adjusting the hood and body to fit properly. Where should I start? Any pointers would be helpful

Thank you for the information. Can you please describe what a Widow's Peak is

I have a non chromed but Rusty painted radiator shell. It appears to be off a Model A style car. What year did they use painted radiator shells

Im in need of two side splash shields with good lower edges. even if the upper part is not good but the lower needs to be good.

Im wanting to reuse my orignal splash shields but the part that meets the running boards is rusted and deteriorated. Is there any parts available to repair that edge?

is there welting or something that goes between the splash shield nose piece and the fender?

Any ideas? new fenders and running boards but the rear fenders are narrower than the boards

i havent posted pics on here but ill try to figure out how to. do you have a smart phone ? i can send them directly to you if you want

I have the front and rear fenders mounted and they fit pretty well. the problem now is that the rear fenders where they meet the rear of the running board are not correct. the fenders are .5 inches narrower. now what???

im putting togather my 1930 deluxe coupe. i have new running boards and im using my orignal splash shields. how do the splash shields attach to the long part of the running board?

thank you thats exactly what i needed.. now i can start making all the parts fit togather...

I have a 2 door deluxe coupe rumble seat.. can someone take a picture of their coupe rear fender and bracket for me.

I have new rear fenders and now need to install the rear fender brackets. its been over a year since i removed the brackets so now i dont know where they mount to. Can anyone help me. A bit embarrassing to ask but fact is i dont remember .

Thank you

Im installing my body onto the frame. what goes between the blocks and the frame and between the blocks and the body. I have rubber shims and asphalt welting but not sure what goes where.

that was very interesting but i dont under stand what is ment by the "cover" "adjust the nut until you get a distance of 11/16", measured from the top face of the rear of the lever, down onto the cover.

im installing the pressure plate on my 1930 model A engine. freshly turned fly wheel , new clutch disk. After tightening the pressure plate I measured the finger to top of pressure plate. the book says it should be 5/8''... i am measuring 1 and 3/8 inch. what am i doing wrong.

Im thankful I asked. im thinking I will screw them in. thank you

Is there any reason i cant weld in my new replacement floor panels?