Search results

  1. A

    1935 Pickup mechanical brakes

    When adjusting the brakes, which direction do I turn the adjuster on the rear of the backing plate to tighten the brakes ( when looking at the adjuster from behind the wheel). When I turn the adjuster, in either direction, the brakes go from on to off over and over as I turn the adjuster...
  2. A

    1932-34 truck dashlight

    Could someone tell me where the bulb socket bracket mounts. It has a single capture nut and the wire from the socket to light switch is 13" long and is 2" from the left side of the dashboard. Thanks in advance for your input.
  3. A

    FN!!STtXx!! Window channels

    Thanks for the input Karl. I bought the regulators from CG Parts listed as 1932-34 pickup truck. I need to replace the roller on the lift arm?
  4. A

    FN!!STtXx!! Window channels

    I replaced the (missing) door window channels and regulators on my 1933 T 1 1/2 truck. The regulators are Vintique and work ok (?); but the window channels I bought from Mac's a while back ( Argentina made) are an impossible fit. The large slot access hole is too small, the slot is too narrow...
  5. A

    Truck speedometer cable

    Sorry about the omissions...the truck is a 1933 short wheel. Al
  6. A

    Truck speedometer cable

    Does anyone know of a source for a 1 1/2 ton truck speedometer cable? Any suggestions on how to solve this . Thanks all in advance, Al
  7. A

    Door window regulator

    Having a problem installing door windows in my 1933 ford truck. The stud on the end of the window regulator arm will not fit thru the hole and slot of the window glass channel. Also, the stud on the driver door regulator is spring loaded and moves in and out, the stud on the passenger door...
  8. A

    speedo cable

    Ford's ton and a half AA and BB need a long speedometer cable, over 100 inches. Does anybody know of a source or solution for a missing cable?
  9. A

    Leaky block

    i'm leaking coolant into the combustion chamber and crankcase of my '48 V8. Any cure?..or just keep driving it until? The leak is in the lifter valley around a lifter bore.
  10. A

    Bracket & level assembly (brake shaft)

    Need the assembly that the brake rods tie into at the frame X on a 1935-36 Ford Pass & Comm. Part no. 48 2458. In good useable condition. Thanks, Al
  11. A

    1935 Pickup truck outside mirrors

    Wanted: Looking for outside, hinge mounted mirrors, glass unimportant.
  12. A

    1933 Truck Hood

    Wanted: A nice straight ,rust pit free hood for a 1933 truck. Thanks
  13. A

    Outside hinge mount mirror

    Wanted: For 1 1/2 ton truck, outside hinge pin mounted mirror. I need one or two arms, the mirrors themselves are not important. Tnanks
  14. A

    Wanted

    stake body for shortwheel base 1 1/2 ton Ford truck. New England area.
  15. A

    260 V8 choke heat tubes

    The two choke heat tubes on my 260 V8 Falcon Sptrint have rotted and broken off at the point they enter the exhaust manifold. What is the best way to remove the remaining tube from the manifold. Also, how are the new tubes secured to the manifold holes?...is it fust a pressure fit? Thanks, Al
  16. A

    Rear Wheel bearing removal

    Is there an easy way of removing the lock ring that holds the grease seal and bearing in the rear hub? Thanks all, Al
Back
Top