Search results

There’s a modern style one I bought works well. I think I got from either Brat ton’s or Early Ford Store

Thank you guys, Brenner’s Corner helped me out yes marvel schebler carb used after Ford parted ways with Zenith as a replacement.

Trying to identify this carb came with a intake/exhaust manifold I bought recently. No mfg. name on the carb that I can see.

Hello looking for a used 1932 Ford inside rear view mirror for open car, painted or chrome with wear. Frank Vento 650-888-9900 fvento@intero.com

Thanks, spent some time under the hood and figured it out, wire male bullet came loose from connector.

Thank you Cas3 will check that and reply in a few days

Hello Gentlemen, I recently remove the steering column of my 32 pick up stock, had the steering box rebuilt, after replacing everything, realized the hold is not working, lights seem to be working fine. Any suggestions? Thanks in advance, Frank

Hello Mac VP, just reading this article and thread, had a similar issue with my transmission over the weekend in about nine months ago pulling the cover sliding the gears back into place everything seem to function fine. Not sure what’s causing it to get locked up. I see in the pictures/article...

Hello guys thanks for the feedback and tips after a few this past weekend, I managed to massage it into place. It opens and closes and sits properly with the gasket in place.

Thanks for all your feedback and thoughts. Got some time in the garage this past weekend. And was able to massage the cowl vent into place and have it close properly with the gasket in place.

Thanks for the input and tips, spent some time under the dash and above the cowl. And it’s much better now!

Ok thanks for that tip that makes sense, and easy to execute

Steve/IL, that's a possibility to check into, I'll look under the dash tonight. But at a glanceit appeared that everything was factory install. The cowl vent (green paint) matches what's on the windshield hinge and other areas where I've found original factory paint. thanks, Frank

Hello David, yes that extra hole is what was used to bolted shut by the prior owner. The lower level ratchet is the one that was in the truck, I tried the new one didn’t seem to make a difference if anything it didn’t work as well. No I have not oiled those hinge pins, I’ll do that but it seems...

So first two photos show Calvin laying fairly flush in place, but the vent is not centered within the opening there’s a large gap on the back. Second two photos show it’s centered where I think it should sit properly, but this causes the front lip to rise up

Here’s the mechanism

Here’s some more photos of the vent

Thanks for the replies, David this truck is mostly original. The fit shown in the pictures is without the gasket and the cowl vent disconnected from the mechanism. It doesn’t appear that the cowl vent itself is bent or distorted. So I’m guessing the mechanism on this truck. This truck was...

Hello, when I got my pickup, someone had previously drilled a hole in the cowl vent and bolted it closed using fender washers. bought a new gasket and spring Seems that with or without gasket in place the the front of the vent will sits up a little. It doesn't close all the way, Is there...

So the windshield is open and I removed all the screws from the under side of the cab header (top of windshield). And the 3 nuts on the topside off the cab header. Swing arms are disconnected. What’s next? I don’t want to start prying and pulling in the wrong direction. It seems like it...