Search results

  1. E

    ****** drain plug

    3/4" pipe plug I believe.
  2. E

    EvapoRust

    Thank you, that is the info I was looking for. The frame is not painted, I can partially see the number, hoping to pull the rest up.
  3. E

    Up date !!! Frozen brake adjuster

    Thumps up. Job well done.
  4. E

    Oil pump

    Put a cheap oil pressure gauge on the pump outlet screw. Should answer any questions.
  5. E

    Thoughts toward Texas

    My thoughts and prayers are with you folks. God bless.
  6. E

    Tillotson carburetor butterfly

    Not sure the exact opening spec's, yes the throttle plate must be open enough to let fuel in to idle.
  7. E

    EvapoRust

    I found my Model A serial #. Will EvapoRust remove enough rust to be able to read the numbers. I can almost read them but not entirely. Thanks for your input.
  8. E

    Instrument Panel

    I may have one, will look tomorrow. If so would be glad to donate it.
  9. E

    B Camshaft

    How does one tell the difference between A and B distributors?
  10. E

    Installing oil Pan gaskets?

    Not sure on the crank seal I THINK you need to trim it to a tad longer and tuck the ends in, some one will chime in on that. The cork gasket all I do is put some wheel brg grease on the block to hold the gasket up until I get the pan in place. I may be handy to cut the heads of a couple of 1/4...
  11. E

    Door hinge pins

    I believe there is a tool specific to that job. Synders has it. A few bucks to save hours of time. Win win for all.
  12. E

    Best way to prep a head before painting question

    I do all the above except the masking. Too lazy to mask. Dip a finger in some wheel brg grease, put a thin coat of grease where you do not want paint. Grease will wipe off with excess paint. Have fun
  13. E

    Zenith carb float valve problem

    One can also weigh on a mailing scale. If over spec's float is leaking and sinking. I have also reused the orig needle and seat which in my case is steel.
  14. E

    Rod nuts

    Just a question........would the oil eventually eat away at the plastic insert?
  15. E

    Generator Problems

    Ground the fields, this will give you full gen output.
  16. E

    Put the oil pan on last night.

    My only thought having screwed up oh so many times is, I am glad for you that you saw the pump, running to start it would have been a disaster. Dont feel bad, we have all been there done that.
  17. E

    Found these

    Ran across a bunch of these today any interest?
  18. E

    Hershey thoughts.....

    This is why it is so important to pass this hobby on to the young. Most will laugh at this but I have had my model A since 1963 when I got out of high school. It still sits out back, obviously in need of TLC. My son has been after me to "git her going". So 50 yrs later i am starting in. I will...
  19. E

    Terminal box wing nuts

    You are correct. I have a terminal box that came off my 30, the wing nuts are solid brass.
  20. E

    Another front drum / brake problem

    Later cars have spring and washer holding shoe against the backing plate. I would make sure there is a little pressure on the shoe towards the drum.
Back
Top