Search results

It comes with a single 1/2 inch jam nut. It’s a new SW temp gauge.

Correct I need a 5/8-18 for the temp port and a 1/2 inch for the SW mechanical gauge

Hey guys I am having my 36 water pumps re built by skip. He told me that the left side water temp port is 5/8-18 , the Stewart Warner gauge I got which is mechanical says that the thread on their temp is 1/2 inch. Is there an adapter to put this temperature sensor in? What have others done ...

Distributor and wire loom holders are SOLD

The problem with the pumps after analysis is that the re production ones have the pully too far out from the body of the pump compared to the original which has the pulley closer to the body this causing alignment issues . I spoke to Dennis carpenter and they said I should take them to a place...

No I didn’t get it wrong .. the mating area from the pump to the heads is thicker than the originals causing the pump to protrude more and thus skewing the alignment. I made the comparison and they are maybe half inch thicker . If carpenter wants to advertise these as exact replacements cast...

I contacted skip and we went over the rebuild and they will be on there way to him this week.

Yeah I think you are right .. I don’t know how this can be solved … it’s infuriating to pay for parts that don’t fit .. you can see the hub of the pulley sits out further than the original.. I don’t see how this is posted as an exact replacement and reproduction

Yes I understand that. I had the original pumps on and there was no issues going to the Dennis carpenter pumps and now the alignment is askew.

Yes the power master was on the engine with the original pumps. The power master has an adapter to run the fan.

Hi guys I have a 36 roadster , original 21 stud with water pumps on the heads. I have power master alternator and e fire distributor 12v and a sharp dual intake manifold . The issue is the drivers side original pump died and the pulley came loose. I got a pair of Dennis carpenter pumps. Put them...

To the top

Still available

Sold sold

I have a set of perfect gear drive polished aluminum air cleaners with real copper mesh and modern paper element. These fit stromberg and Holley carbs with a 2 5/8 “ neck and are 4 5/8 “ around . They sit in place with a set screw and have zero damage nicks or scrapes. Would look amazing on a...

Stromberg carb is sold

Great thanks so much for the reply , sounds straight forward , I appreciate it a lot

Hi guys . How do you remove the license plate holder from the rear taillight on a 36 roadster? It’s between the light and the housing itself. Any help would be appreciated. Thanks

Get them for XMAS

To the top