Search results

  1. A

    y block ticking

    Check for rocks stuck in treads of tires.
  2. A

    Feedback on modern tube shocks for Model A's

    Installed a pair of Ken Davis shocks on the rear of my 30 roadster,they worked perfect felt the difference immediately.
  3. A

    Normal stud?

    had one with a sleeve, bugger to remove head!
  4. A

    Model A won't start

    I have had problems when my car sits usually winter to spring, most of the time I clean points and then check for spark , always worked for me.
  5. A

    Don't hammer me for asking this..

    not a drop in at all,1932 ford has a different frame.
  6. A

    Nostalgia

    oh for crying in the sink! Dirty lying dora
  7. A

    Leaky Gas Guage

    if you use any flame to repair tank make sure you clean to properly prevent possibility of explosion!
  8. A

    No more stalls at stop signs for me!

    I had a problem with stalling at stops when I searched the problem I found the gas linkage was slightly bent causing idle on high speed circuit. Bent linkage so throttle closed and engine idled on idle circuit solved problem.
  9. A

    throwout bearing Q...

    I had three different ones with three different manufacturers Germany, mexico, and U.S they all sounded dry when I spun them.I was concerned so I packed grease in from any lip and joint I could find, took a while but worked excellent.
  10. A

    Please ID these

    possibly for the brake actuator rod and cup on the end where it joins with king pin.
  11. A

    Where to start ??

    I had a bad vibration when I applied brakes,found a nut on my front spring perch under axel was loose.
  12. A

    Model A power

    You may be running too rich by opening gav too much. Half to 3/4 for start and 1/4 to run when warm some say to close when on highway.
  13. A

    Enigine work

    I,d clean it first before jumping to any conclusion. I,be seen worse clean up o.k.
  14. A

    Rear wheel lean

    worn bearing surface on bottom of axle housing,remove drum and check.
  15. A

    A or B Cam recommendation

    I used a stipe ib 330 cam works great low and high speed.
  16. A

    Best plugs..??

    I use 3076 auto lite plugs gapped at .032, cam high compression head 5.5,runs excellent.
  17. A

    what plugs needed

    I use auto lite 3076 because they're inexpensive and work well, cost around 3.00 each.
  18. A

    engine noise

    thanks Bill hopefully mine will too. I have about 1000 miles on it now, I may try a fiber gear.
  19. A

    engine noise

    the noise is from timing gear region I've used a stethoscope tool to narrow it down, I think James is correct when I looked nothing appeared to stand out as the cause of noise. Aside from noise it's a good powerful motor. may try a fiber gear. Thanks for help good to have a few opinions.
  20. A

    engine noise

    I have a noise in my engine, there since day one of new engine, it's a clack or slap noise. Re set lifters no differance still there, removed timing cover to see if spring on cam plunger broken or missing, everything o.k. Noted the seat for cam button was loose fitting sloppy, wandering if that...
Back
Top