Search results

The wiring was correct even though thr sender with two wire connections is on the right side of engine. When I grounded the two wires together, the gauge needle went from "H" to "C". However, as soon as I disconnected them, the needle went back to "H". I then removed the sender with two wire...

The wiring schematic shows the temp sensor with 2 wiring terminals on the driver's (left) side of engine. Mine is located on the passenger (right) side of engine. Will this affect the temp gauge's reliability?

The gauge needle stays on "H" while engine is cold, but the needle begins moving left when engine is started and stops about halfway between mid-point of gauge and “C.”. As engine warms up, the needle moves back to the right and stops near “H.” Any help understanding what would cause this...

Thanks for posting the picture. I agree that it should be easy to figure out how the spring is attached so that the handle returns to its correct position with adequate tension to prevent rattling. The picture suggests that the spring should be positioned near the top of the pin; however, the...

I need help positioning the hood latch spring that comes with the Hood Latch Mounting Pin Kit for a 1950 F1 (Part # 7C-16897-KIT). So far I have been unsuccessful and wondered if someone who owns a 1948-50 F1 would be kind enough to take a picture of the spring correctly attached to the hood...

Hi folks, Does the speedometer cable go on top or behind the firewall insulation inan early 1950 F-1 Pickup? Thanks for your help! Joe

I need an original choke cable for an early 1950 F-1. My original cable had a chrome piece that fit against the dash behind the knob, and the cable was secured by clip behind the dash. The chrome is damaged on mine, and the replacement cable does not have the chrome piece and fastens to dash...

I need both inner fenders for an early 1950 F-1 pickup truck. You may message me on this site or call me at 864-882-2139. Thanks for your help. Joe

Is the radiator shroud original and in good condition? I didn't know 1948-50 F-1's came with a shroud. Is the lower grill valance in good condition? Would you take $150 for the shroud, valance, and steering wheel? Thanks, Joe

Has anyone purchased a radiator from LMC Truck? If so, what is the quality and who manufactures their radiators? I have contacted several dealers, and it seems that US Radiator manufactures radiators for most of them. LMC Truck has the best price for a radiator, but the reps who answer the order...

Larry, Could you share with the condition of the fenders - rust, dents, etc. - or upload pictures. Thanks, Joe

If the dual wiper is still available, I would like to purchase it from you. Thanks, Joe Toler (864-882-2139) (email:jtoler@clemson.edu)

A=Model Man, Do you still have the 48-50 pick-up fenders and top panel connector? Thanks, Joe Toler

Is your truck an F-1 or larger truck? Thanks