Search results

Katy, Yes I have and they have been good

Has anyone had experience with buying parts from speedway motors. I need an open car windshield frame and a stone guard and they are less expensive than the Model A vendors. Could I have your opinions.

I have a transmission that I am having trouble to identify. It is a top loader ,three speed open driveshaft. The number stamped on the clutch housing is. 6E7297.Help please..

I have been checking all of the Model A Ford vendors for a3:78 crown and pinion gear set and no one is selling made in USA gear sets . The sets they sell all seem to be made in Italy. Have any of you used these gear sets and were they good or was there problems?You input would be appreciated.

Wanted. 3:78 crown and pinion Must be made in USA or original Ford. Must be either new or in excellent condition . No worn out stuff please.

Re: Dot 5 brake fluid and leaking wheel cylinder’s I measured all bores on wheel cylinders and they were exactly on spec. I found that the cups were soft and pliable. I took a new Raybestos cylinder apart and found that the new cups were very rigid and the fit was perfect and much stiffer...

Re: Dot 5 brake fluid and leaking wheel cylinder’s Yes, fluid is leaking and brake dust and fluid is making a mess

Re: Dot 5 brake fluid and leaking wheel cylinder’s I have new residual valves but noticed when I removed the. rubber boots on the wheel cylinders, I see leaking fluid and it looks like a black dust in the leaking fluid. It’s like the rubber in the piston cup is failing.Could the piston cups be...

Dot 5 brake fluid and leaking wheel cylinder’s In the past five years,I have been constantly having wheel cylinders leaking. The first set of wheel cylinders were offshore . I then purchased Raybestos wheel cylinders about two years ago and today,both rear cylinders are leaking and have...

In Les Andrews book volume two he says use hubs and drums 4 same year. Use 1940-41 drums and hubs on 1939-41 backing plates. Use 1946-48 drums and hubs on 1946-48 backing plates. Why couldn’t you use 1946-48 drums on 1939- 41 backing plates.

Wanted one 1929 Business Coupe oval window frame. Must be in good condition. Contact bjnewbery@ shaw.ca

All hagerty customers need to read the fine print on your policy. In Canada, it states that you are only covered for club events. In other words, you are not covered if you are out for a drive and it is not a club event. I called head office and he said that was correct. Read the fine print on...

I had a similar problem but my rotor was to high. I had a new distributor body that was to low and caused a premature rotor failure . I suggest you get a origin Ford body and measure and compare the two. Some of these replacement parts are not up to Ford spec.

I had severe problems with my hydraulic brakes aa well. I have a brake booster on mine and the car would dive to the Center of the road. I am using DOT 5 brake fluid. I tried adjusting heavy to the passenger side and nothing worked. I noticed a dampness on the left front wheel cylinder. I...

I had severe problems with my hydraulic brakes aa well. I have a brake booster on mine and the car would dive to the Center of the road. I am using DOT 5 brake fluid. I tried adjusting heavy to the passenger side and nothing worked. I noticed a dampness on the left front wheel cylinder. I...

A real easy way to check rods is to instal crank ,torque mains to spec.Instal all four rods and pistons. Torque rods to spec.Turn engine upside down in engine stand. Rotate engine a few times and observe the position of the rod in the piston. They should all be in the centre of the piston.If...

I have taken 6 V 8 oil pumps, short style 1932-48 model 50 pound spring. They all have failed shaft bearing surfaces and failed bushings. I previously installed a new melling and at 5000 miles ,it had the same problem. My Cam is excellent, new drive gear and it all looks good. My question is...

Al ,I would stick with the 16 inch .The Bridgestone tire is very close to the Model a tire in outside diameter and it is probably 2 ply sidewalls. They would be perfect for your F150 overdrive so you can keep your speed up.You will find perfect rims,just keep looking.

I run at 32lbs and it handles well .I have them on my29 Hardtop pickup and on a 29 Business Coupe

Yes, I have two Model A s and both have Bridgestone Ecopias . They are LRR which gives you a excellent ride and easier steering. I have over 20,000 miles on one set and not much wear. The old 21 inch bias ply would barely make 10,000 miles and they would be worn out . I used three sets of them...