Search results

Thanks for your comment ,now I know .

It’s close to brake backing plate on axle housing . WHERE IS THE GREASE GOING..?

I will call brattons to try sort out . I’m almost positive my glass is original. Did fit original felt which was worn out. Fred

I ordered a pair of 32 inch window felts , but the groove seems too wide compared to my glass thickness. Do I just narrow the felt by hand . This is for my 30 4 door ts Drivers side back window Hope someone can help. Fredski

AER. A eager runner Other information , noise on cold start up then seems to quiet up after a few minutes. Maybe I should leave it as is.

Probably not ,but I hear a little engine noise at start up for a couple of minutes. Fred

Thanks . Ido not want to disturb exh. manifold to muffler pipe since it perfectly fitted and not leaking. Frd

Do I have to remove intake / exhaust manifolds. I would rather not. I do have adjustable lifters , it a AER MOTOR,with about 800 miles on it. Fredski

I vacuumed the bugs out of the radiator ,with the help of a tooth pick. Then got under to see if I have any oil leaks. ,no real leaks just a small drop, found on the floor sometime. Next cleaned front window (bugs) and put on rainex. Next opened a beer lite up a cigar sat on a chair and looked...

Wonder how this is my 2005 GT convertible is not made of steel which I discovered since a magnit does not stick to it? I have had car since new no rust. Just wondering?

Air idle screw, turning it in or out really makes no difference in idle. Gav is okay , i run about 1/4 turn out. Fred

Adjusted as model a org. Tell how to. Idle smooth and slow yet ide mixture screw makes really no difference in or out. I have all renners jetting kit ,installed Last year. Plugs run very clean. Maybe I should not worry engine starts and runs perfect otherwise ?? Fred

Doesn't make a difference if gav closed or open . I adjusted it to 3/4 turn out only because it should be out some. Car starts and runs well as it is. Fred

AER engine with 2000 miles, 5.5 Snyder head which was recommended, Motor was run warm for 5 minutes.cyl 1 94 lbs. cyl 2. 90. Cyl 3. 91 Cyl 4 91. This on a non balanced motor. Anyway just wanted to share this info, and was happy with results. Fred

My 21inch wheels were powder coated 3years ago, and when I examined them, the coating is everywhere perfectly. I remember this because I waxed the wheels outside and inner areas. Finish is still perfect. They were coated by RLD coatings in Ottawa cnd. Fred

Don't get it , what are trying to tell Steve?

Wish I could say the same mine worked perfectly for about 2 months. Put the original back on which is original to car and were fine now. Fredski

Also have 5 tubes from macs, and going on my third year no air loss. Did my own install and was very careful doing so. Fred

If your light lever is at the top ,it's very unlikely your advance lever ,is opposite as well. Can't be.

You just didn't tell him you removed the radiator? Fredski