Search results

You can remove the pan with the engine in place. No need to lift it. when you remove the bolts holding the pan don't forget the one from the top at the right side rear. You may need to rotate the crank so the front counter weight is pointing up towards the cam. If the car has a single exhaust...

Back again.

Rest in peace Ol' Ron. Thank you Ruth for keeping us updated. These pictures are from my and TomT's visit in 2016.

32/9 = 3.55:1 11/39= 3.54:1 The diff in the avatar is marked 11 39 and checked put to 3.54:1.

The Bob Drakes mounts are the best. The Speedway mounts do not have the cupped base washer. There is nothing to prevent the cushion from expanding and flattening under load.

No problem for a push start. You will have a short circuit when you try to connect the positive posts. Many sparks and possibly a battery explosion.

Rest in peace Bill. You will be missed. I first met Bill at the Barners bash in 2010. Jeff, this is the tool Bill made for the OP sensor.

drolston I would say the one you got is defective.

V8Coopman, Would those have been on Tonner and larger trucks?

I did a clutch replacement last year on the avatar pickup. The trans can be removed from the floor access. The rear end and drive shaft has to be move back about 6" so you have enough room to pull the trans back and out. Disconnect the brake line, e brake cable and speedo cable. Unbolt the...

Mart, These dimensions are for the adaptor button that is in my manuals CD. I think they give the info you are looking for. Chuck

A Standard Motor Products PS60 has been on my 59AB in the pickup for 12 years. Verified it with a mechanical gauge.

Here is a better pic of the 40 Standard/pickup grille.

39 deluxe. 40 standard/pickup has a wider center bar. Link to the front pic of my pickup below. https://www.fordbarn.com/forum/album.php?albumid=2248&pictureid=18361

If you stop, you KNOW it will follow you home.

Good job getting all of that done alone. I don't know if I would have been as fussy about the hardware as you were. I agree with mfirth. Take us for a ride.

Bttt

Check this thread: https://www.fordbarn.com/forum/showthread.php?t=203088 The screws are #12 X 1 1/2" on the sides. I believe they are the same on the center bracket. I have not removed that to check.

Bump for 2021.

This kit came from Dennis Carpenter. The only place the needed trimming was over the windshield header. The headliner panel slides between the roof and the header. I had to trim about 3/8" off the front edge to get a proper fit above the back window. The filler piece under the back window...