Search results

I have a 30 Tudor with hyd. brakes. I am cleaning the bearings and re-packing but the seal I received from Macs is way too big. Are the drums different for the Hyd. System? My old seal is about 2 -28/32, the new is almost 3.2" Any ideas where I can get a new seal? I old one is kaput.

I have a 30 Tudor with hydraulic brakes ( There when I bought it) When I tighten the axle nut to 100+ pounds the drum will not move. It is positioned firmly against the backing plate. If the nut it tightened and then backed off and cotter pinned it moves but will still give a obvious grinding...

Hi from Midland!

The cheap quality (?) of some of the replacement parts. Not up to the specs of Henry.

Try turning the GAV valve all the way in until it seats. I tried everything and found this simple solution stopped all leaks.

It is a crankcase breather tube.

Whenever I work on my A and the engine in running the fan really bothers me. Is there anything on the market (Temp or Perm) that will make it safer?

I have recently begun work on a 1930 tudor and have some serious steering issues. The wheel steers very hard, will not return after a turn, and has a lot of play. The front wheels, when moved manually left to right have at least one to two inches of play. The wheels also seriously shake...

Between the heat and the "standard puller" it broke free. Thanks to everyone!

I have been unable to loosen the drivers side rear drum. Passenger side came off fine. I have used a puller, tried heat, and am now out of ideas. Any suggestions?

Thanks for the info. It is set at .20 and runs fine, I was just curious is there was a dwell reading.

Is there a dwell angle for a model A point setting? I cannot seem to locate anything but gap.

Thanks for all your help guys. It turned out to be a plugged line between the sediment bowl and the gas tank. I really appreciate all the advice.

The ignorant one here again. The engine will start up, run strong for 15-20 seconds and then just die. I have..replaced the carb, removed the add-on inline filter, removed the gas cap ,installed a new coil. The timing and dwell are O.K. Chocking the engine will not keep it running. How...

Ignorant here again. I replaced the coil, removed the add-on fuel filter, replaced the carb, removed the gas cap, Could it be the ignition switch? The condenser?

I am a new model A owner who did a stupid thing. I cleaned the battery and was unaware the A had a positive ground! Never heard of such a thing. I have checked the timing, points, wires, rebuilt the carb. The problem, It starts right up, idles for about 15 seconds and then just dies. I know it...