Search results

I have a system similar to this set up. After a few thousand miles I have had no problems and I have no blow by inside the car--I don't miss it!

Put two on my rebuilt 39 four years ago. I had to change to leaner jets and the shoulder screw that secures the accelerator pump lever was machined incorrectly (too shallow so it backed out several times--I called to ask for another one-they sent the incorrect one again:)). But they have...

I did my 39 tudor by myself. I can't give any superior advice other than patience. I heard a rumor that the factory workers assigned this duty only lived to their mid 30s.

I used a version of this setup on my 39 rebuild (from fordbarn and HAMB, many ideas can be found). I now have several thousand miles on it with no problems and no blow-by.

thanks

Are these kits, or their components, available today? I have a 39 deluxe I would like to convert.

nice job! I have 39 Deluxe Tudor as well---still a rolling project--but I enjoy it.

make a pointed tool for your pneumatic chisel--place it in the center of the pin--hit trigger in brief spurts--it will very likely come right out.

I have had dual set of SS 97s for two years with no problems. Had to change jets to fit my rebuilt engine--too rich out of the box.

sorry about that pic--I tried to crop it but....

Outlaw. Unfortunately the pics of the details of my setup were lost in a cell phone problem. I used many ideas from the fordbarn and the jalopy journal. Mine is 39 bored out 221ci with an L 100 cam and the induction shown. I blocked the draft inlet on the oil pan and adapted a setup much like...

Here is a fordbarn pic of a system similar to that I installed on my 59A. Everything is hidden. After about 3K miles it seems to be working fine. No blow back--no fumes. The pcv valve was for a small displacement chevy. don't have the part number.

I had the same experience with my rebuilt 69A. I panicked at first--then I read the relevant fordbarn articles finding that it is not unusual. I fabricated a stud extractor to take out each of the four studs that were leaking. I took them out individually and purchased a high quality thread...

Didn't know you could refill the tube. whats the proceedure? Had my original gauge professionally rebuild--so far no problems.

Patience pays off. I once had a six cylinder Healey motor with all six bores seized. It took about six months of gently tapping each piston with a hammer and a wood block. It finally began to move--went on to rebuild it. That was over 25 years and thousands of miles ago. Good luck with your...

Thanks for the pics. I will checkout Drakes.

anyone know the correct material and color of the lining of a 39 tudor glove box?

How do I disassemble the front back rest of my 39 tudor to install new upholster? any Pics out there?

My 39 deluxe requires a few minutes of "at speed' driving to come up to correct reading. If I check the gauge by just turning on the key I get nothing. The reasons have been explained on the FB having to do with the construction of the system--sending unit and gauge.

12v Rebuild Batteries Plus for starting and a 6v rebuilt Batteries Plus battery for running.