Search results

I wasn't aware a 50 ford Loadamatic dist. had a vacum cannister.

I have a standard 8cm block with heads no internals. It has been magnafluxed 2 minor cracks no problem. $500. brewer_l@sbcglobal.net calif. 530-401-8660.

I have run the stock distributer and Carb in my 53 for 20 years and 60000 miles. I run 18 to 19 mpg. As long as I leave the car stock I see no reason to change.

I did not realize that was a stupid question for the experts on this Forum.

I should have added the car has power steering would that create extra problems?

Is it possible to remove the oil pan on a 292 in a 56 Victoria with out removing the engine from the car? Thanks Len

Any problems using edelbrock carb with 1956 distributer. Thanks

If you initially fill the OD and trans with oil will the oil move between the two so it is possible to just check the trans. The car is a 53. Thanks

Any recommendations for a shop that works on the Borg Warner electric overdrive on the west coast. It is in a 53 Victoria.

How can I determine what rear end ratio I have? Thanks

I am in need of a original 1937 gas cap. Leonard 530-401-8660 brewer_l@sbcglobal.net

Never used Bubba Chevrolet converted dist. with vac. for 8BA. 530-401-8660 brewer_l@sbcglobal.net

Can anyone tell me the No. of teeth on speedometer gear for a stock 56 ford with three speed + overdrive. Thank You

All I have been able to find is the 85-90 GL5 gear oil is this the correct oil to use. Thanks

Thanks for all the comments I will try a new filter and gasket and see what happens.

Recently rebuilt 292 great compression, no smoke, doesn't overheat has excessive oil coming from draft tube assembly on side of block. Any suggestions as to cause. Thanks Len

On my 56 I am on my third pump from Napa. All three developed a oil leak in a short amount of time. Any other supplier that has a pump that doesn't leak? The leak is not from the mounting flange It is the shaft that that supports the actuating arm. Thanks

Anyone had any experience opening up a 51 horn to check the adj. It appears to be a closed unit. Thank you Len

Any tips for installing horn wire on A 51 FORD. There is no wire in shaft now. Thank you Len

I installed a 12 volt alternator from C an G on my 53 comes with mounting bracket very simple hookup and works great.