Search results

Single master cylinder.

Thanks, I will use your suggestion. This car was restored to go to a museum in 2002. Great looking car but they did not restore anything mechanical. Just cleaned up and made to look good. It has been a challenge.

I am working on a friends 29 Coupe. The brakes were converted to juice brakes many years ago. My problem is adjusting the front brakes. If I adjust the brakes so the wheels spins with little resistance, it should work but if you step on the brakes the brakes wont release. I replaced everything...

Wow, I am one post closer too.

I have used Eastwoods products before and had good luck. I had the frame powder coated on my 29 CCPU. Will see in time how it works out. Great so far.

I use Logo Lites. A little pricey but easy to install and they work great.

I used a replacement pulley and a stock belt. Works fine.

I installed a set of splash guards and running boards from Howells. The splash guards were ok but the running boards mating to stock fenders was not good. Original parts were not available to me so I had no choice.

Thanks for the information. I checked out Marco's. A lot of good pictures! 1Crosscut - I would like a photo of your top showing the folds. My wood joints are all sanded and I will recheck everything. Wrong time of year for that hot sunny day. Maybe a hot garage will do. What glue is best for...

Great find! I saved the cab on my 29 ccpu from becoming part on a rat rod. I'm going to go find some bushes to beat.

Thanks again for all the nice comments on my first drive a while back. I only have two major things left, roof and visor. I have watched all the videos, etc. on installation of both but still have questions. No one shows how to do the rear corners on the ccpu. I assume they have a fold in them...

Thanks everyone! All help is appreciated.

I see where Burts says it has to be lengthened. Like so many other after market parts I have purchased, you have to make them fit.

I got a new manual wiper from a vendor. I thought finally something simple to put together, one nut, what could go wrong. Alas I does not fit. My window frame is from a 28 AA and still has the original tube for the wiper. The new wiper is too short to fit thru the tube and allow the handle to...

Thanks everyone for the nice comments. Its snowing today so glad I got to drive it yesterday. I will post as I progress thru the last few things. What does everyone use for windlass for the doors. I don't see it listed in Mikes or Macs.

I will be getting him back to the honey due list pretty soon now!! I got to ride on the second trip around the block, very comfy! It has been amazing to watch the transformation from boxes of stuff, to a gorgeous pickup! Good Job My Sweet! Richard's Wife, Catherine

I took my first drive in my 29 CCPU today. What a thrill!! Not completely done yet as you can see and I didn't get the pictures in order. That is the trailer full of stuff I purchased from Plucker to start with. Just a year and a half later and around the block twice. I even had tears in my...

Tom, our weather is a bit different here in Montana. Low humidity and it was 52 degrees outside this mourning. Garage stays cool all day. I am close to lifting the engine out so things are going good. Really hard tearing my A down when finishing the total rebuild is not too far away. Yes I am...

Thanks Tom. I was hoping you would come back with a - well all you have to do is - kind of message. I am just not excited battling the flywheel again. Doing anything tomorrow?

I have to pull the engine to put in the long rear main bolts. Flywheel is in the way.