Search results

Oiling is stock and I have a sealed water pump. I may flush the system and try it again before tearing it apart. Winter season here now so I won’t be driving it for a while. Most of my driving is a short drive to town 5 miles away. Towards the end of summer I was doing some 50 mile and up...

I used a Best brand head gasket with copper coat. When I think about it there are no oil passages in the head gasket area. The pressurized oil is in the cam area. A crack somewhere is what I’m thinking. It’s funny coolant does not go in the oil. I drained the coolant into a small container then...

I drained the coolant out of my banger today and there was a substantial amount of motor oil in it. I drained the oil also and there was no coolant there. I drained the coolant this summer to pull the radiator to install a harmonic balancer and there was no oil in the coolant at that time. So...

I have the same mirrors and had the same issue. I reversed the c-clamp and it changed the angle of the mirror stock

The main journals are .001 out of round. Rear journal is 1.618 and 1.619. Spec is 1.624

There were shims in the front cap all others there was none. All of the journals look nice but measure under size.

I disassembled the engine on my A and found this broken bearing, front of the rear main cap. Other than this the rest of the bearings look good. I assume there is no repair to this?

I have a spreader. I’m curious if the amount of side force effects felt vibration on the engine. And how much spread needed to install is normal. Are all frames about the same? I am installing new rubber pads and bolts.

My frame needs to be spread 1/4 inch to install the engine on my A. Is this tension part of how the side rubber mounts work? Is there such a thing as too much tension?

I knew nothing about model A’s before I bought mine. Been a great learning experience. But I am mechanically inclined

Are the rear radius rods bolted solid to that new transmission bracket? If so how can the rear end articulate?

Update on tire diameter. Excelsior comp H 5.75/6.00 tires measure 30.5 on stock model A 19 inch wheels. Coker spec lists 31.

I am running stock wheels. I was using a different calculator. A gear change to 3.54 would yield around a 147 rpm drop. So if the next size up tire 6.00x 19 comp H is truly a 31 inch tall tire from the 29 I have now it would yield about the same rpm drop. Has anyone ever measured a 6.00 or 6.50...

I have a stock 31 A Tudor with 5.00x19 tires on it now. I would like to lower the overall RPM at cruising speed by changing the rear tires to either a 6.00 or 6.50. In stock form is there enough power to use tires that size? Eventually I’m adding a different head and intake. I’m running...

Problem solved pm, entire bowl vent passage was plugged. M

I have one of these carbs on my 31 A that will not idle or rev up without the choke partially on. The mount flange was severely warped, which I fixed. Is there other areas that have a warp issue? This carb is remarkably clean inside. Does anyone know what size the idle jet orfice hole should be?