Search results

Thanks All

Have a guy interested in buying my truck. He wants to pay with a USAA bank check. He has agreed to allow the check to clear but if it's real I don't want to hold him up either. I'm not a military guy and never heard of this bank. Anyone? What is the best way to verify? He has offered his...

Was there another way to liquefy the sludge? could he have used a detergent oil and frequent oil changes to remove that sludge?

What's the story here?

Seller history is one item.

A question and a comment: first question is could you have put the truck into gear ( while off ) and rocked/pushed the vehicle back and fourth to free up the starter? I have a t5 on the back of my flathead and I once already had to increase throw on the peddle so the trans slides into gear. I...

I had a similar issue. Rebuilt engine on a sitting a long time truck. Oil pressure was fine for the fist two weeks and then starting reading low. After a little panic, added a second gauge and the new gauge was reading much higher. Changed the sender unit for the factory gauge and then they both...

what does the gauge say when the key is on in the morning before the engine has been run? Basically the same question as above

delete

Questions: I'm not an engine guy at all, barely a change a tire guy. I understand that our Flatheads suffer from lack of breathability and that the Ardun setup changed that ( possibly by relocating the breathing portion of the engine to the new heads...). Please correct me if I'm wrong or add to...

....

Plenty of other advice in this thread and probably good advice but his questions were specific.

Could the low rear end gearing have over stressed the trans gears? I would think that third gear would have the most load on it though but maybe not since he was pulling a loaded trailer coupled with the long diff gears. First gear really worked to get the whole assembly moving.... You guys know...

This trans is still for sale. The first guy never came through but it's really time to clean out the garage. A few guys asked me about what gears were in there. I took a better photo and counted the gears I thin you guys want to know about. If you need more info let me know. This trans does...

Here's a DIY I found

But when you raise the hinge point doesn't the throw arm ( below the hinge point) become too short or are you lengthening it as well?

Pete, lets see your short throw adapter. Did you make it or buy it? I believe the concept is the higher the hinge point the shorter the throws. Is that what you did?

I modified the original shifter. I cut off the ball and then heated and bent it to where I want it. Then just welded it to an aftermarket shifter that mounts to the top of T5. Put a little home made boot over the welded connection and Bob's Your Uncle.

The real problem in this clip is the lack of parking spots, the abundance of parking meters and the overly aggressive meter maids handing out summons. Oh,, did anyone notice the red light camera too?

Video Please..... Does anyone know the builder or his reputation?