Search results

Use marvel mystery oil, follow direction on can. DAVE

itt

I am looking for a otwell heater in good condition. thanks DAVE 413 863 8307 turner falls ma Have found one. thanks DAVE

I am looking for a 29 fan shroud in any condition. thanks DAVE

Marvel Mystery oil 4oz per tank full . DAVE

How to add millage to a rebuilt speedometer? Can a drill be used at a low speed or another method

I am using a TINY TACH it works great. DAVE

I am looking for a 29 radiator cap that will fit my original radiator. 2.20+ inside cap diameter. thanks DAVE

I found where the noise was came from, sloppy fit on wrist pin bushings. thanks for all your help DAVE

I am looking for a B 3 tab breather cap. thanks DAVE DBAET@comcast.net

Sunday I had two of my mechanic friends over to listen to my noise. They both agreed it is subtle and goes away above idle I am going to run it and enjoy my 29 warmed up coupe.

I live in western mass and am a fair/god mechanic DAVE

I called a model a engine rebuilder that did my main bearings he said piston to cyl clearance is the problem, noise does sound like piston slap but why it goes away with 1 and 4 cylinder shorted together does not make sense to me.I think I can check piston cly by dropping the pan with a feeler...

One of my model a engine professional says it probably has wrong clearance piston to cyl, he says run it. That is what I am going to do. DAVE

I rebuilt the motor and had professionals do the boring and main bearing work. I am quite sure the cam plunger spring is in but where would that noise on the engine be most prominent? DAVE

The noise sounds like a thud not a rattle if that helps. DAVE

I disconnected the fan belt that got rid of belt noise, next I shorted one plug at a time stayed the same which I previously had done, than I shorted 2 and 3 stayed the same next I shorted 1 and 4 the noise went away. It seems like I have a issue in cylinder 1 and 4. What should be my next...

I am running a non slip belt and alternator, 12volts. DAVE

I have shorted out the plugs, didn't isolate the noise. DAVE

The motor has new everything Snyder pistons Brattons tin base rods new main babbitt timing gear timing gear plunger spring, valves, valve guides, spring, flywheel lighten and clutch balanced. I am running a B distributor set at 10 degrees it had less noise with A distributor at 0 degrees. The...