Search results

what is a "big leak" to you

Ok, it is still on the truck, I will not be able to remove it until wed at the latest

1929, but I can tell you mine had a 4 blade fan not a 2 blade

Thank you, how do I tell the difference?

So, me being 17 and not the sharpest bowling ball, I ordered the wrong rebuild kit when I did my carb not knowing that there were different versions, so I don't want to make the same mistake again. I have a leak at the rearward most seal on my water pump and I want to know if there are any...

Autozone Brand fine?

So after my deal with the leaky carb, it runs and doesn't leak but needs coolant, which is the best coolant to put in it. Thanks

Thank you for that info, me and my boss had been trying to figure out why there were different carbs on different trucks

I do not have access to an oven to do it in, I myself am in the middle of moving, and we do not have an oven here at the hardware store

Well, my boss is an older lady with a 59 big brake corvette and a 65 vette as well, so there is no shortage of gear heads and grease monkeys here. Were going to try and seal this one with a product we sell here, and if that doesn't work, we will go ahead and fit a zenith and then tackle the...

How hot do I need to get it and what kind of clamp because I would most likely need quite a few. :)

The only issue I see with this, is that the piece where it doesn't meet is raised, which means I would have file everything else on the carb but the spots where it doesn't meet. That seems like a lot of time and a lot of room to royally mess something up

that too is warped, checked it yesterday, so should I get a new carb or resurface the one I have, and if I keep it, how do I resurface it.

We do have glass and I have checked the one side opposite from the one with the float attached and it is most definitely not flat, I cannot easily check the other side as there is a fixed piece that protrudes from the mating surface, but how would I go about resurfacing these pieces?

Is two gaskets better than gasket maker?

Tilliston(I hope I spelled that right) model X

Hello, my name is Tyler, I work at Wallace Hardware in OCNJ, and here in our store, we have a 1929 ford model a pickup that has been with the store for nearly 80 years. The truck had not run in around 4 to 5 years, and a few months ago, me and a coworker began tinkering with it to get it to fire...