Search results

Draglink found thank you Chuck

Looking for a good useable draglink for a 41 ford car.This is a bar with no bends i believe 35-41 are the same thank you

51woodie all 41 -48 fords are the same not sure on early or later

That motor I believe is not ford notice the pivot arm its straight fords were curved. You may not get a correct sweep

its good

Thank You I need to check my wiring to the relay

Hello I have a 41 ford trying to get the horn to work.I converted to 12 volts a while back I had no luck with the trumpets so went with a modern horn.I tested the horn and works I have it wired through a horn relay.I am trying to figure out the wire to horn ring how does it break contact.How...

one set of interior door handles not perfect slight chrome pitting but still shine up complete set asking 25 dollars shipped.Center dash strip which I only have 1 sold the other could use a replate 10 dollars shipped.Exterior door handles both have some dings in them 15 dollars shipped

Offset gen bracket off 8ba nice shape the band seems a little distorted with a slight bend.And tough pivoting needs oil asking 35 dollars shipped.And a set of thermostat housing cast 15 dollars shipped gen bracket sold pending water housings sold

The full length diecast trim with the clock cut out are they rare? I always see the ones without the clock cutout.Were these aftermarket could have ford made these?

yes duel trumpets I have been working on this car off and on for the last few years.As I have been thinking I had these horns off and painted them.I forgot I did that. I also am leaning towards a ground.I do have the 6 volt relay I was told it still may work? This week end I will try it out...

Thank for the response I will check for voltage at b terminal wont be till weekend. Yes I did check horn button to s terminal and it works with a voltmeter. Correction I went from battery to button and it worked

I need some help from someone who has gone from 6 to 12 volt and changed polarity to neg. I can get my horns to work but not off the three terminal relay.I have insulated the horns that may be a problem. s terminal to horn button h terminal horns b terminal to pos on battery this is a 41...

please delete just sold the car

block and parts not for sale

I have a 8ba block I hate to dispose of but need to get it out of my dads garage. I was going to rebuild it decided to repair my 59 block. I do not have any history on this block I can say it was stored under cover there is no heavy rust cylinders look good the cam and valves still in block...

Hello I am looking for a fuel and temp gauge and temp sending unit for a 56- 61 ford thank you paul pbc64@yahoo.com

Alan i was told a 6 volt coil may work i had one it turned up missing . The advice i have been given will be a coil between 1.5 and 3 ohms. i will price them when i get it i will let you know how i did thank you for your help paul

Alan I have tried internals and externals with a ballast resister . I have heated them all up to where they are no good as jonc mentioned I will find a 1.5 ohm coil . what I do not understand he is running a coil with a internal resister and a ballast resister?

yes i have tried both ways i have tried just the internal got hot then tried external with ballast resister and got hot when i run the the internal coil i am not using a ballast resister