Search results

Looking for Upholstery and padding or quality seat cover for a 1946 Businessmans coupe. This seat has the back that flips up.

Ford cylinder sleeve 3.187 I.D. Ford NOS or aftermarket okay. Looking for at least four.

The radial tubes have seams that spiral around the tube. Standard tubes have seams that intersect at 90 degrees, running the full diameter and cross sections. Hmmm....At what speed does this make a difference? I would like to know too.

Will send you a PM about that piston you need. I have several.

Babbitt bearings can be done near Spokane at Strong Engine. He is located in Otis Orchards. P.M. me for the phone number.

Looking for a steering column tube in good condition for a 1935 pickup.

GB is absolutely correct. I have purchased a '28 and a '35 this way. One was from British Columbia. The owner in Alberta needs to go to the RCMP and get a form showing proof of serial number and owner. That should get the vehicle into the U.S.

In need of a set of NOS 81A-6333-A main bearings. Standard crank, standard block.

Thanks Ford Barn. Found a lock....still need a nice steering tube.

In need of a steering column tube and column drop with working lock and keys for a 1935 pickup. 1935-1937 pickup should be the same for the tube. Lock assy. should be the same for 1935-1937 passenger/commercial.

In need of the clutch/flywheel cover part to the 2 piece oil pan.

In need of a pair of head gaskets for the French/Brazil small Flathead V8 that was designed by Ford. The year of the engine is dated 1959. Thanks in advance for any and all help.

Two one ton Express Pickup wheels. One wheel above average condition, one wheel has a small rust through hole near the valve stem hole. Wheels are stamped "BUDD 44630". Lock rings included. 509-826-1365

Very nice cross shaft assembly. Nice and tight with very little wear. 75.00 plus shipping.

Looking for a reverse rotating camshaft that allowed the engine to run backwards. These were used in boats with twin flatheads, or in the 40's and 50's on race engines to change the direction of torque. 59A-B or 8 BA Okay.

Btt

Need 48-6050 aluminum cylinder head marked HT. For domed pistons.

Looking for a set of pistons for the Mercury 4 inch stroke crank, 3.187 + .030. NOS or used. Good condition used okay.

Looking for a set of pistons for the Mercury 4 inch stroke crankshaft. Standard bore.

After I remove all the old oil and grease from a flathead, I soak my blocks in a 55 gallon drum of 10% livestock molasses to 90% water for 7 days. Cleans the inside water jackets really well. I then wash with a 4000 PSI washer and a 200 degree hot box. Final is to blow dry with a leaf blower to...