Search results

The engine sold. It's going to Ohio to be put in a 37 Coupe. Thanks to all that looked at the engine.

The plugs should be in when balancing. Take the plugs and weigh them that is the amount that the balance will be off if left out.

We just put a small bead with the TIG you do not need to weld all around the seat. Three spots normally will shrink them. I no longer can see good enough and keep my hands still so this job has been passed on to the next generation. Trying to train the third generation but my 12 year old...

Sold 4-3-2022 I found a new home South K.C.

Once it leaves your hands it is not your reasonably. I would cringe some times when i would hand a costumer a crankshaft and bearings knowing they did not have the knowledge to install it. The internet has helped with information and videos. Keep up the good work. 10% of your costumers cause 90%...

Love the old tools. It is nice to see the kit complete. When you get it to work show us some pictures or video we just might learn something.

I have ground lots of cranks in my life. You must remove the plugs to proper clean the sludge. Most old stuff that ran non detergent oil the plugs hid lots of sludge. 4.2 Jag engine hade a big plug about 3/4'' every one that I removed had a nickel size plug of grindings and sludge. Also when you...

I bought mine from Vanpelt sales. I had to buy the whole kit when I just needed the nipple then on the run stand one flew off and it would not stay on. I used silicon lube to assemble the water pump it must have made the rubber soft. Pricey lesson learned.

Own a piece of history. May still have some finger prints of old long since gone Ford mechanics. For Sale Black/Decker valve grinder with cooling tank. Blue Point/ Snap On seat grinder with 4 stone drivers 11 pilots [ includes Ford flathead and 60hp flathead] 5 brushes 33 stones stone sharpener...

I just bought a Van Norman 777s boring bar in pieces with the thought of boring my own blocks. The best shop around here is 4 to 6 months back logged. The worst shop is telling everyone 90 days. plus i like to have control of my engine projects.

I would ask my self these questions. 1. How many miles a year driven. Most Classic cars see a limited miles you don't need to build it for 100K miles. Cast pistons and standard rings will work. 2. Rpm wanted. If you are going for high rpm then forged or hyper pistons are needed. 3. Boost are you...

You pm me asking if the cyld heads i had were aluminum. I cant pm yet so i am posting this answer all of my cyld heads are cast iron. I wish you luck in your search. Enginepieces

I have lowered the price of the engine to 2050.00. The engine will be on the run stand for the next 2 weeks then it will go in storage. I need the run stand for a Jeep engine break in. Thanks Gary

The lobes on your distributor is worn you will have hard time setting and keeping them set. May be time for a good distributor shop to look at it or replace it. The roll [Speed up and slow down]of the engine could be the blower most blower engine's have a roll that is the cool thing about a...

60hp Ford Engine for sale. Running engine on run stand. lots of spare parts.Run stand not included. This is a 1937 cast sided engine running on stand it holds at idle cold 30psi warm at idle 25psi with 30w non detergent oil. No water leaks runs cool. Spare parts complete set of new...