Search results

If you are on your way back west from the Hersey Show on US 30. I am only 1 mile off of US30 so You can stop at my parts sale.....

If you are on your way back west on US 30 in Indiana from the Hersey Show. I'm only 1 mile off of US 30 so you can stop at my parts sale.

Sorry, sale starts Friday Oct. 11th not Thursday..

Go to Model T parts for sale to view photos of my parts sale. My son got them on that forum but not the A. Reminder no early sales of parts until the morning of 10/11/24 to make it fair for everyone. Eastern time zone also...

I have been getting several emails wanting me to sell a part now. As stated in the flyer No Early Sales. This makes it fair for everyone that has looked at the photos and expects the part to there on Thursday morning Oct. 11th... Also, the location is in the eastern time zone.

See attached flyer

Model T Parts Sale. Save the date. See attached flyer.

While trying to work out my sagging frame issue. I have found that the drivers door hinges are bent. I have looked in a couple of supply catalogs and I am not locating any. Are these being reproduced?? Or will I have to locate a nice set of used ones. I can straighten these I believe, the...

Thanks for everyone's input... Looks like I will be lifting the body up to get the job done correctly. One good thing is that there is no interior yet. I have started it once and it runs great with a completely rebuilt engine with insert rods..

I have run into another problems with my 29 Murray project. The doors and hood are not aligning correctly. I was not aware of the issues a sagging frame can cause with door/hood alignment. Until after I read Les Andrew's book Vol 2. He states that the frame can be straightened but you need to...

Yes, rechroming them has crossed my mind. The original handles have some corrosion on them but they are not pitted. Being a frame off restoration I was hoping for reproductions that were nice and shinny. I am sure that someone else has had this issue..

I have come up with an issue with replacement exterior door handles for 29 Murray. I purchased from Snyders product # A-702350-C and A-702351-C door handles that fit a 28-29 4 drs, Cabriolets and Victoria's. These look just like mine with scroll type handle. The replacements have two issues...

Thanks for everyone's input,

The body is all painted and just about ready to be put back on the frame. The chassis is a rolling chassis with the front fenders, splash aprons and running boards etc. installed. The webbing is under the splash aprons and front fenders. I have from Snyders part# A-5000-P (Body Block Pad Set)...

I forgot to say that I was repainting it and not buffing it...

After looking over my recent paint job, I found more dry areas than I wanted to try to buff out. So, I have started the wet sanding as Brent stated. I few areas I had to use 400 grit and then worked up to the 800 grit as it was too rough for the 800grit. I have a good 8 hours of sanding and...

I have checked out the video link and it gives me some good info. I will have a problem terminating the correction area as it is above the rear window. But like it was stated I have nothing to loose. If I am not happy with the results and want to wet sand the clear coat to where I can apply...

I have two coats of clear on the car. I own a buffer and supplies but have never used or seen one used (correctly). Both ideas sound better than doing the entire car over...

I base coated and clear coated my Murray body this week. I have an area above the rear window that I believe is clear that is now rough. I waited my times between coats and when I was doing the clear I noticed that sunlight was beating down in that area. I think it was too hot for the clear as...

Mike, That helps a lot. I hope the guy moves the business to Bluffton, IN as it is much closer for me..