Search results

Congrats to you, Val & the Eherenhofer's !!!!!!!!!!

Epoxy primer is for bare metal

Check out Lebaron Bonney

Hog rings WERE used. Depends on seat and body style. Mine is a early 31 Murray Fordor

Put the steering column/assy. in after putting the body on the frame. No?

Where are you located?

Hi Ken, am hoping you are doing well!!! And Helen ALSO!!! Thank-You Mark for letting us know

Hi Mark, Am wondering why you needed these? Were the copper gaskets not good enough? Are you able to use the gland rings? How did you find these guys? Haha, as you can tell I am intrigued and full of questions.

There are all sorts of applications for this style. They make them open ended also I have one & use it for the A head nut at the distributer, don't remember why I needed it when I was a mechanic years ago but there was a reason I spent the money haha. Not just for Model A. They are not a special...

Had the same problem. The 535 flashers are junk, they say heavy duty(load compensating) but are NOT. Go on e-bay & search: LL535 Tridon. They work & made in the USA!!!!!

Try looking behind the dash panel on the gas tank. Thats where I found mine

Very interesting, THANKS for the replies! Larry, every Otwell I have seen TOTALLY clears the distributer, thats one of reasons I like the design. Ed, Otwell must have done different designs? The upper hole & not clearing the distributer??? Pepsi mechanic, that is what I was confused about. That...

Hi Guys, I am in the process of checking the fit of various heaters, I have an existing door in the firewall, & came across the Otwell exhaust being so low it lines up with the bend at the floor board AND the recess for the engine! I see it won't fit mine, but how can you possibly put a heater...

Need some pics. There was a previous post, not to long ago, on manifold heaters

I sent you a Pm on 11-25 with no response??????

Here is an article from Hagerty that might be of interest...

2egls, Your pic is not there. Would like to see it.

I think if it was open there would not be airflow to the rear. Isn't that why the side port is there, for summer? That cover you are showing, is the top screw the only one holding it on? I have that same threaded hole. All of everyones pics don't show the top. The other thing is all the nubs...

Slick-50 is BAD stuff only because of the amount of teflon in it. It actually impregnets(spelling?)the metal & prevents break-in on new rebuilds & cannot be removed. I had my boys racing gokarts with Briggs tiller motors & I tried the stuff. The inside of the crankcase had what looked like snot...

Thank-you